Tylo SUPER SPORT-U8 Heater 8 kW - Page 8 - Answered Questions & Fixed issues

Page 16 and 17 of your manual refers! https://www.manualslib.com/manual/528161/Miele-G-641.html?page=16#manual ..

check thermostat circuit --relay--heater

looks like this has a magnetic drive pump and are not common to leak. so disassemble and locate loose or cracked part and try silicone or epoxy to do the repair. I recommend Majic lube for rubber o-rings and gaskets Lay Spa Teardown

filter clogging / dirty

check with the manufacturer

Hi I have an Mspa Camaro P-CA090/069 I had an E1 Error code which I have sorted I believe it was the filter, but I'm finding the tub is struggling to heat up it was 26.5 and after 24 hrs it's only 28.5 I would be very grateful if someone can help me with this problem. Thanks

if cord is faulty replace it

Moved category from Cars and Trucks to Pool and SpaContact Haywood direct. It sounds like an erratic delivery of gas, or faulty ignition. Contact details on the warranty page.https://www.hayward-pool.com/assets/documents/pools/pdf/manuals/H-series-H100ID1-ABG1001.pdf..

plumbing supply --online search

is the gfi popping or unit just shuts off --notify customer service and ask about problem or sending it back for a new one if defective

New Zealand? We are in North America so our searches get a bit flawed. Try this https://www.google.com/search?q=Kent+Sahara+Spa+pool+main+board ..

That impeller is obsolete. It is woodruff keyed to that shaft, IF it is not plastic you can use a jaw set of gear pullers. If it is plastic you many need a bearing puller and a gear puller.

Send it back.

get scumball and let them float in pool

yes have to use the solar heat aux

clean salt sensor if ok bad sensor

over middle burner if ok check for cob web in burner orfice

bad seals in wet end to motor replace seals or whole pump

I don't have any information on the Laars S2 heater. However, the gas pressure requirements are usually consistent for all appliances. The manual for the Laars Mighty Therm 2, MTP2. gives the maximum (3.2 kPa) and minimum (1.2 kPa) incoming gas pressure on page 13. The manual is available here: https://www.laars.com/images/uploads/products/1211J-NH.pdf . I hope this helps. Cindy Wells