20 Most Recent Electric Mobility Power Electric Scooter Power Wheel Chair Safety Flag - Page 2 Questions & Answers

no problem i can order you one for about 5 pounds regards

Sounds as if the battery is very flat. Take the battery out and have it checked and charged.

Hi. Most chargers with only two wires, have a small bridge wire from the
black ( negative ) wire to the middle terminal of the connector. This disables the controller while the machine is charging. The charger will still work without this bridge wire, but the scooter will still operate normally.
There are a few different chargers around that have an internal relay that disables the scooter, but these chargers are normally "on-board" chargers.
Good luck. Neil.

check and make sure free wheeling brake is not on

contact Sunrise Medical @ (800) 333-4000
ask for tech support see if they can help you Hope this helps

Any 4 amp charger you can find will work to charge your batteries. Preferably find one that has an on/off switch on the charger. You should be able to find one on ebay a lot less than what the scooter repair store quoted you Check around your neighborhood someone might have a second charger that they are not using. Since Medicare will pay for a new chair every 5 years someone might have a extra charger laying around. Hope this helps you

You may want to check the bearings in the casters, that can cause a scrubbing noise and cause the chair to not turn well.

If there is a chirping noise, that may indicate a motor failure. There is a left and right motor, so if one is not working well, it can cause the power chair to not drive straight.

please rate my answer as a thumbs up 1 to 4 please,im disabled myself & do this cause i care not for profit.If the batteries are [AGM or GEL] you could have ruined them by letting them run down.Start again with the charging & follow the guidelines as to charging.& go from there,have the batteries tested,if they are ok,ur mobile again.Also you could visit:www.alldatasheet.com & download as a PDF File the info on your product,you can keep in Adobe Reader or Print for future.I have an electric scooter myself & the charging of the batteries is really important,if i just go 1/4 mile i will put them on charge.i have a trickle charger,mine can be left on for 3 months if im right.But IF BATTERIES ARE NOT USED WHEN FULLY CHARGED,BEST TO DISCONNECT THEM,SO THEY KEEP THEIR FULL CHARGE.HOPE I WAS OF HELP COLIN.

Hi. I have seen all sorts of material wrapped around the axles behind the wheels, long grass, string, rope, fabric. It gets picked up by the tread on the tryes, and gets wrapped around the axle as the machine drives along. This can wear or damage the seal in the side of the gearbox, where the shaft comes out.
Other times, if the machine has had a lot of use, the bearings can fail, and allow the shaft to move up and down, this movement will damage the seal.
Lift the machine on to blocks, remove the wheel, and check the condition of the bearings and seal. If it needs a new seal, and everything else looks OK, then try your local engineering supplies store. They might have the correct size seal for a cheaper price than a new gearbox.
You might have to add some more oil or grease, if too much has leaked out.
Good luck. Neil.

contacted Hoveround repair team, they are lousy and slow to fix anything but, unlike you, at least they are free.

check the fuses

red light meaning batteries low, have you charged it up ?:

Regards
GeWiz.

Not a reset problem. More like the chair is not in gear or a battery problem.