Ps P&s Double Pole Ac Switch 20a Brown 120/277v 20ac2 - Page 4 - Answered Questions & Fixed issues

The load it too high for the gennie or the breaker is getting warn or is already warm from sitting in the sun.

Electrical... | Answered on May 13, 2020 | 87 views

It is sinusoidal.

Electrical... | Answered on May 13, 2020 | 76 views

B&S recommends 5W-30 synthetic oil as their preferred oil for my generator.

Electrical... | Answered on May 02, 2020 | 50 views

Replace motor.

Electrical... | Answered on May 01, 2020 | 202 views

They may not waste wire but layout per breaker could be designed better by a USPS worker. Or chimp. Also staples go through metal siding with no protection for wires. Above problem fits this as i found a staple going through a wire almost starting a fire. Some staples on interior walls zig zag in no place in particular.

Electrical... | Answered on Apr 23, 2020 | 308 views

I know nothing about your generator - sorry.

There are two basic types of alternator - those with a self-energising rotor and those with brush gear to the rotor. If it is the latter, perhaps a brush is sticking sometimes.
To go further you really need a manual so you can check the circuit through.

Electrical... | Answered on Apr 20, 2020 | 58 views

The PC1050 is a 2 stroke ;-)

Electrical... | Answered on Apr 01, 2020 | 148 views

Your lamp is a three level dimmer as opposed to a 3 position switch.

The 3 level dimmer chops the voltage where as the 3 position switch powers 2 separate filaments (50, 100) inside the bulb either separately or all at once.

The 3-way bulb should not be necessary for an electronic 3 level dimmer. Any incandescent, or dimmable CFL or dimmable LED bulb should work.

Electrical... | Answered on Feb 22, 2020 | 112 views

Generally, the kits save you a couple hundred dollars over buying each tool separately. Plus, a tool might be included in the kit that you don't usually use but that you find to be very handy and it might become your new favorite tool

Electrical... | Answered on Feb 07, 2020 | 229 views

Assuming North America...

Likely the existing switch is a 3 way. The switch has 3 connections?

Yes, and the existing switch is not labeled on/off?

Yes, then what you have in the box are a feed wire (white) and two travelers (red and black) that go to at least one more switch that controls the same lighting fixture(s).

So given your description there is no neutral wire and you will not be able to have a receptacle in the same box without running a new cable.

Electrical... | Answered on Feb 06, 2020 | 104 views

If you ran out of fuel or changed filters it is necessary to prime system (filters) and bleed air.

Electrical... | Answered on Feb 06, 2020 | 86 views

Had the ' engine m/n invalid shut down on my 12resv Kohler generator. Off light was blinking red. Clicked the select button 3 times to clear fault and confirmed Y ...then went to the Gen set information which is a few more menu down with the arrow button. It did say 12Resv so had it blink and rest it but same thing. so rest fault again and went back to the gen set information tab and I changed it to 14resv and all cleared without out fault and tryed to hit run for a min . Ofcourse it's wrong model number so would not start but did not fault. So I went back to the Gen set information menu and put it back to the original 12Resv and it started right up without fault. I placed back in Auto and been working ever sense. Has friend had same problem and as with mine it happened on a night where power went on and off multiple times. Think its really just loosing informsiton to recognize the unit to controller and needs reset or flashed if you have the OnCue will work as more thing good idea I'd not sure your battery is good over 12v to pull terminals and physically check with a multi meter should be liek 13 4 volts or so for optimal starting. Good luck this was a head ache and see others have had problem ..tony Michigan

Electrical... | Answered on Jan 22, 2020 | 445 views

Diesel generator:

Electrical... | Answered on Jan 17, 2020 | 147 views

If you need to purchase diesel generator set, please refer to

Electrical... | Answered on Jan 15, 2020 | 102 views

If you have decided to opt for the CRUD dashboard Generator, you are certainly taking a wise move. This is an application that simplifies the hassles and hardships in managing and administrating the MYSQL databases. Using this application, users can design the best dashboard administration panel that aids the process of analyzing the databases. This application comes with more than 20 themes and templates. You can easily customize these templates to instantly design your own dashboard administration panel that will enable you to handle the database in the most proficient manner. As such, you can certainly opt for this application with a good faith and confidence. Reviews about this application comes exceptionally positive. This implies, the application has earned the appreciation from database professionals from all around the globe. One can Learn about crud php mysql For more information about this application, please visit now!!

Electrical... | Answered on Jan 12, 2020 | 95 views

277 - m = 57

add m to both sides and solve

Electrical... | Answered on Jan 10, 2020 | 84 views

Diesel generator set:

Electrical... | Answered on Jan 09, 2020 | 138 views

Not finding what you are looking for?
Ps P&s Double Pole Ac Switch 20a Brown 120/277v 20ac2 Logo

0 questions posted

Ask a Question

Usually answered in minutes!

Top Ps Electrical Supplies Experts


Level 3 Expert

85239 Answers

Brad Brown

Level 3 Expert

18563 Answers

john h

Level 3 Expert

23515 Answers

Are you a Ps Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides