its not uncommon to have water at the end of the programme providing the results are ok dont worry. most of the water is the drying steam condensing and running back to the sump. the dishwasher pumps this out at the begining of the next prog.
TO SLIDE THE UNIT OUT YOU MUST UNINSTALL THE MACHINE. START BY UNSCREWING THE TOP. ANY SCREW THAT HOLD THE MACHINE IN ON TOP AND SIDES IF APPLIES. CHECK THE DRAIN AND FILL HOSE TO SEE HOW MUCH LINE YOU HAVE TO PULL OUT UNIT. IF DRAIN HOSE IS SHORT DISCONNECT FROM UNDER THE SINK. IF FILL HOSE IS SHORT TURN OFF WATER GOING INTO MACHINE AND DISCONNECT HOSE. IF ELECTRICAL IS SHORT THEN DISCONNECT FROM TERMINAL BLOCK BUT MAKE SURE THE POWER IS OFF. THAT SHOULD DO IT.
check this out. I suspect loose connection on relay pin at back of pcb. Try tapping near the buttons and see if you can re-start it even for a second. This is how i isolated problem to the pcbs in the control unit. I have the loose pin with solder blown off - I just need a new soldering iron to fix it. If you not able to tackle yourself, qer.biz will do it for you, or replace with a reconditioned board for reasonable charge.
you probably have something stopping the drain pump operating (like a tooth-pick or piece of plastic that won't break down in water) its a take it to pieces job i'm afraid but if you are fairly mechanically adept you can do it yourself. the drain pump is quite small and nearby to the drain outlet- you need to remove the case and release the drain from inside the unit- remove the pump itself and you'll prbably find somthing stuck in it- remove and re-assemble. In the meantime DO NOT use the dishwasher as you will 'burn out' the motor as the pump rotors are jammed.
Hope this helps
Quorahttps://www.quora.com > What-does-CL-mean-on-a-dish...
This code means that the CHILD LOCK or CONTROL LOCK feature has been activated. When activated, all buttons will not change except the washer's door and the ...
9 answers · Top answer: First, look on your dishwasher to find a label that shows the manufacturer and the model number. ...
JustAnswerhttps://www.justanswer.com > Appliance Repair
Oct 28, 2010 - You should just be able to just turn the power button off, then turn it back on and the CL should be gone.
1 answer · Top answer: Hello, and thank you for using this service. I'll be helping you with your
..https://www.youtube.com/watch?v=Xr4DBwACUW4
Dishwashers come in standard sizes. Your old one is 60 CM wide and made for built in.
https://www.bosch-home.ca/en/supportdetail/product/SGU4025AU/31
DISHWASHER 60 CM BUILT-IN/BUILT-UNDERSGU4025AU/31
As long as the new one is also for built in, the dishwasher will fit. Measure the height of the space you have. There may be a little height adjustment on the feet.
..
AI Bot Answer Deleted.
In the base of the dishwasher above the floor there is a plastic tray that has a leak sensor. If you see water behind the machine than it means you have a 'spraying leak' as the sensor cuts off the machine as soon as it is triggered. It is likely to be a leaking hose on the pump. It can also be caused by the machine over-filling.
An E15 error code indicates that the safety switch has detected water in the base of the dishwasher. Your leakage protection system has activated. What can I do to fix the E15 Error Code on my dishwasher? Please turn off the water inflow and contact Bosch Customer Support for assistance.