Top 20
Kirby Ultimate G Bagged Upright Vacuum - Page 3 Questions & Answers
GREEN LIGHT AND MOTOR
The green light is an indicator that your brush is rolling smoothly. If it starts to flicker and you smell something that smells like rubber burning you need to do a couple things; one is remove the roller and clean off all of the hair, string, etc. Next you want to replace your belt. Just because the roller isn't turning doesn't mean the motor and the belt aren't either. If your roller gets jammed your belt will continue to spin and it will eventually wear down in one spot and break. Replace the belt, clean the roller and your should be fine.
Kirby sparks and smells
it probably needs new carbon brushes in the motor,DO NOT run anymore for fear of burning motor out.
Kirby ultimste g series green light?
that means its working properly. If you have no suction then it is usually the belt and or the bag. so make sure your bag is not full , make sure everything is attatched properly and the green light is on.... The Kirby is the best vac out there and little suction should never be a issue for us.. I am a proud owner of the sentria..Love it..
Louder than normal
something is blocking the way of air, like a piece of paper being sucked up into the tube.try to remove it, and it will be fixed
My kirby G6 2000 no pwer
More than likely you have a short in your power cord. however if you want to know for sure take machine apart until you can put an elec meter on switch where cord is attached. plug machine in and test the end of cord that is attached to switch if you have 120volts at that point its your switch thats bad. if you have no voltage or anything less than 110volts at the switch replace cord
I cannot get the belt onto the motor shaft
take head off machine, look in round hole at back of head pick up the belt with the lifter to the 12 o'clock position first the refit head onto the machine, then release belt lifter to the square position
Kirby ultimate G series
sounds to me like the peoblem is with the brushbar,try taking the brushbar out then trying it again if it's ok i would sujest the bearings on the end of brush are bad and need replacing..
Not finding what you are looking for?