20 Most Recent
Honda Karcher G2400HH-R Pressure Washer - Page 2 Questions & Answers
Had presure tostart cleaning @ then press.
if the motor is still running fine when this happened it is either a failure in the linkage between the gas motor and the pump. or the pump itself. if it looks like the motor does nothing whatsoever. it may be the link between the two. if the motor does a little bit, then the problem may be with the pump. Try turning off the engine while spraying and see if the pressure drops at all
Karcher 3600 gx390 backfires
Usually this (back-fire/after-fire) happens because of a dirty carburetor, or bad gas. Gas can go bad with age or it can be bad because of water from condensate. I'm not familiar with this particular engine, but if it more than 1 spark plug, a fouled-out plug can also be the culprit. If you clean your carburetor, I suggest just using a bit of gas to soak it and brush it etc. That carburetor cleaner is rough stuff and it will burn you badly. I don't use it unless I've got a stubborn one. Hope this helps.
Cant pull start the pressure washer
Turn water off to the pressure washer, release pressure by applying hand pressure to sprayer. After water pressure is released, turn water back on (should not have motor running without water.) then try to pull start.
I have a pressure washer
1. make sure you have all fresh gas in the tank.
2. choke on
3. engine switch on (red thing on the side)
4 fuel switch on
5 make sure pressure is off hose (keep the trigger pulled)
mess around with different choke positions and see if that works
Won't start, small engine guy said carburator needed to be flushe
Hi lackeyapda:
Fire Air Fuel
Remove the spark plug, plug it back into its wire. Hold it close to the metal frame WITH INSULATED PLIERS. Pull the cord and see if you get a spark. If no it is the coil, plug wire or a safety switch. If yes
put it back together. Take the air filter off. Spray some "easy start" or "carb cleaner " into the carburetor. Try starting. If it starts for a moment then dies, you do need to clean your carb.
Oil is coming out of
sounds like the seals & o'rings are faulty.get the model number of pump and purchase a kit for the pump.replace all seals and o' rings.this will stop the oil from the pump going through the nozzle.
I have a honda excel 2500 psi , where would the
Many of the excel units don't come with a pressure relief valve but instead a thermal relief valve, it really depends on the model number of the pressure washer. You should only replace the thermal relief valve if it is leaking.
I can't get the nozzle
More than likely you aren't doing anything wrong, try putting some grease on the o-ring inside of the quick connect socket and push the nozzle and wand against the ground and slide the brass ring down. If this still doesn't work I would recommend replacing the
quick connect socket with a new one.
Not finding what you are looking for?