Top 20 Karcher G 2600 VH Gas Pressure Washer - Page 4 Questions & Answers

I had this problem and partially fixed it accidentally by taking the whole thing to pieces a d re-assembling it and it worked...fir a week. ITS THE GREY BUTTON ...after further failing to release detergent I read about the Grey button being depressed and mine was too ..solid I couldn't get it to pop ip and this is why. Take the bottom cover off to show the detergent tube in its holder...undo the two screws holding the black bracket and gently ease it out...then replace it ..but here's the key.. the bottom of the bracket needs to sit under the grey button ...when I pressed the grey button it on one occasion pushed down lower than the black bracket ( it slipped past the ledge of the black bracket) this prevented the Grey button from coming back up and squeezed the detergent tube closed. So make sure the ledge of the black bracket goes under the bottom of the Grey button.. This took me 5 mi a to fix rather than the 1 hour totally dismantling the whole machine. Remember when pressing the Grey button to clean the cover not tu push down too hard as it will slip below the bracjet ( got to be a design error ) Happy cleaning ???? Andy

Try this link: https://www.youtube.com/watch?v=4WZgprLndhU

Here is a post that will help you. http://www.fixya.com/support/t27260394-check_oil_level_karcher_kb2020

K?rcher UK Good afternoon The WV does not have a serial number - Please input "000000" Into the "Serial Number" box. Please note - the registration is not validation of your warranty. Your proof of purchase (receipt) will need to be provided, should you have and problems with your machine. We hope this helps, If we can be of any further help, please do not hesitate to contact us. Kind regards, The K?rcher Facebook Team also: Where the serial number on the karcher WV window vacuum

My Karcher has a reset button as part of the cord. If yours is the same, try that

Maybe press regulator was reset before the unloaded was installed and needs to be set at lowest and then increased as needed.

try here https://www.manualslib.com/brand/karcher/pressure-washer.html

Possibly. The amount of "badge engineering" going on, its possible they are the same machine with a different name sticker. You would need to have both to confirm.

Sorry we have no part info here.

My account pin on 0711825797

indicates a blockage at the wand jet

The trigger valve either needs new o rings or possibly just to be snugged up a bit.

check gfi plug for failure

https://www.pressureparts.com/OwnersManualsK2.aspx/ https://www.pressureparts.com/OwnersManualsK2.aspx

Jack, This YOUTUBE may help point the way? How to Diagnose Pressure Washer Electrical Problems Also it appears that your K5 has a GFI? WITH THE POWER DISCONNECTED: Can you jumper ACROSS the GFI and CAREFULLY see if your K5 powers up? While I found plenty of parts lists, I found no schematics! Darn. Anthony

blockage in the wand nozzle jet

Hot water, not boiling, pour over the joint and then try. I take it the joint is the standard push in type. When re-fitting, a smear of grease around the joint would not do any harm.

Try there tech support

https://www.manualslib.com/manual/286316/Karcher-K-2-89-M.htmlmanualslib has a download option you have to tell it you are not a robot and may have a capta picture test.click on a page of the manual and you will see the download button at the top of the page .

Good Morning, Here is a link giving some insight to your issue. Hope it helps. Good Luck! Pressure Washer FAQ Low or No Flow Briggs Stratton