Top 20 Breville JE900 Juicer Questions & Answers

Sounds like the belt that drives the blades broke. You will need to bring it back to the store in which you bought it from if it is still under warranty. Otherwise, get on the Breville website, register your product, and then find out about the warranty and returns.

If you can, soak the mesh basket in some hot water, boiling if possible. Many times this will break up residue

You might have been able to find a replacement seal for the top but if the bottom is leaking that means the seal is gone there as well and that means replacing the container. The real problem is finding any of these. And when you do the cost is going to be as much as a new unit.

I'm afraid the best advice is to replace the entire unit. The only thing is to make sure you buy a quality unit if you want to get any useful life out of them. A cheap unit is going to start leaking within a year or two (about 30 seconds after the warranty runs out) a good unit will give you hopefully another 5-10 years of use.Might cost more now but you won;t have to replace it that quickly either.

The motor sounds like it overloaded, I doubt it has a thermal cutout fitted (in which case you could leave it off for a while and see if it works) I doubt it has this feature and if it is the motor then the unit should be replaced.

I found this very enthusiastic and informative web blog. It answers the cleaning question pretty well. Makes me want to get one:)
http://brevilleje900juicer.ash.com/

I had the same problem. It must juat got a bit stuck - I gave it a really good twist anti-clockwise and it came unstuck and popped lose.

hmm, i cant tell if this is the same as my juice fountain. mine just twists to the side and then you can lift both pieces out together. then the filter just falls out when i turn it upside down.

flip down the lever to pull it all apart.

rinse out the lid, food pusher and base(that the mesh filter sits in).

scrub out the mesh filter with a dish brush or the included brush if you have it. be carefull the grater-like parts at the base are very sharp. make sure it's clean by holding it up to the light. if there are any particles left clinging to the mesh it will seriously interfere with the effectiveness of your juicing.

you can line the pulp collecting jug with a plastic bag so that you dont have to clean that out as well.

it's best to clean everything immediately. if for some reason you can't, at least rinse the plastic parts and leave the mesh basket to soak until you can get back to it.

if you have any dried food or staining on any of the parts then a soak in water with lemon juice in it (maybe the juice of 3 or 4 lemons) should help soften up particles and strip away stains.

hope this helps....

:)

go to my site and download the last entry in PDF format. I will be removing this link in a couple of days so be sure to save itl.

http://tricia8765.fatcow.com/HELPGUIDES.htm

I found it here:

http://kitchen.manualsonline.com/manuals/mfg/breville/je900.html

We had a Breville juicer which we just recently used but after a few hours it stopped working. May I know if whats the problem with it. We tried to open it but we can't figure what cause the machine to stop.

www.brevillle.com

Breville no longer exists as a brand.

Warranty not dependent on registration. Your receipt is the key to any and all warranty repairs.

Sounds like the shaft bearing is going out.

There is no machine for consumers that takes out all the pulp.

Breville Parts eBay

https://www.breville.com.au/media/mediaappearance/2737/BJE410.pdf

take it to an appliance repair shop, get a quote then if dearer than a new unit ,junk it