Questions & Answers
Have a Stanley Fat MAx
there is a little black button on the end where the blade comes out. With the blade in the out position,push in the button and pull out the blade. With button pushed insert new blade or turn the old one around to use the other end.let go of the button and you are ready to go.
905 views | 1 helpful votes
I just purchased the FATMAX Utility Knife --
the blade section pivots to swivel
when doing that it allows you access to the blade storage area that holds up to 7 blades, if the extra blades arent in place perfectly the handle won't close properly, if your problem is with the blades themselves, make sure that the slot in the blade is aligned with the holder perfectly
718 views | 0 helpful votes
How to load blades on stanley #10-788
This knife is ****. To load... you have to push the slide all the way forward. Make sure the switch is set to unlock. PINCH THE BLADE WITH YOUR FINGERS AND WIGGLE IT INTO PLACE. Then you have to use every ounce of thumb power to relock the switch.
Once you are done, the blade will still come out in 9.9 / 10 times you cut something.
2,113 views | 7 helpful votes
How do i change the blade in a stanley fatmax?
You do not have to remove any screws. Extend the blade outward
using the thumb slide on top of the knife. There is a small black pushbutton on
the opposite side from the lock button. Depress the button on the side and
using the other hand, grab the blade with your thumb and forefinger to pull the
blade out. It may require a little wiggling. Now the new blade can be slide in
and locked into place. The black pushbutton controls the locking mechanism that
keeps the blade from pulling out.
3,808 views | 1 helpful votes
How do you load a new blade?
At the back end of the knive (the curved end) press the black piece through the yellow rounded part and the yellow front and the black back will part, now slide the yellow part back to reviel the blade folder. Fit new blade then refit the yellow part on top of the black part and slide the yellow part foward to lock it back in.
1,074 views | 0 helpful votes
I disassembled the Stanley 10 - 788 utility knife completely how do I put it back together
This utility knife reassemblies similar to the original. The only difference is this model uses two screws and that plastic insert. You will align the two metal halves and bring them together. Use care that the blade does not fall out of its holder and the little black plastic piece stays in place, near the blade. This may take a few tries. after you bring the two halves together you will carefully separate the bottom end (farthest from blade). Separate it just enough to slide the plastic insert into position. Once the three pieces align you will know. With little effort the two metal halves will close together. Install the two set screws and test for proper function. I'm including a Youtube video that shows how to properly change the blade and what it will look like after it is reassembled.
655 views | 1 helpful votes
Not finding what you are looking for?