20 Most Recent Toro Co M/R Blwr/Trmmr Rear Bag Kit - Page 5 Questions & Answers

The float needle might not be shutting off the fuel. The float needle opens and closes the float valve to allow fuel to enter the float bowl. If the float needle is damaged, the carburetor will continue to fill with fuel until it overflows. If the float needle is defective, replace it.

not normally unless the motors are the exact type and size

no they do not interchange directly

maybe you need a new starter

140 inch lbs

have you asked your dealer about this problem yet?

go see your local dealer .

If the key is good then the damaged flywheel will not prevent it from running but it is a failure waiting to happen.

Check for compression by removing the spark plug and firmly hold a finger over the hole and pull the starter cord. Compression should forcibly push against your finger and make a "Pffft" sound.

If you have compression, remove air filter and spray a short burst of starter fluid down the carburetor throat and promptly start. If it runs for a few seconds and stops, then it is a fuel issue. Otherwise check for spark.

Once you get it running you should replace the flywheel.

check the blade if it isn't bolted tightly most likely that will fix they act like a flywheel

you can have a pc welded aND RE THREAded in there

Contact Toro directly o request the instructions.

Contact Toro to request the routing diagram.

Manuals are here https://www.toro.com/en/parts/partdetails?id=7103 ..

Request the wiring diagram from Toro.

https://youtu.be/OaYbBNHfoYI

Did you gap the plug?

Suggest you remove carburetor bowl and make sure it is clean.

Which engine?

Carburetor needs cleaning? Throttle linkages? Spark plug okay? Ignition timing okay? https://www.google.com/search?q=oro+snow+blower+model+38185+runs+but+not+fast+enough ..

That's an older Tecumseh engine. The magneto and points are underneath the flywheel.

See Taryl Dactyl instruction video on how to remove a flywheel without a puller and 100s of small engine repair videos.

https://youtu.be/SYVjw7fw8RU

Youll need specs for point gap and timing instructions. See free manuals at

https://www.mymowerparts.com/pdf/

Parts diagrams.

https://www.ereplacementparts.com/toro-38120-000000100150001980-snowthrower-parts-c-121776_121777_122189.html

This sounds like classic vapor lock. Heat from the engine is vaporizing the fuel in the carburetor before it gets into the cylinder. Next time it happens, try icing down the carburetor and fuel lines and see if it starts up.

Maybe a warped deck