Hi sir
1) Please open the covert where the main motor is, disconnect
the connector from the Incline motor.
2) Turn On the treadmill, and see what happen.
3) If the problem does Not appear , is indication the controller motor board is defective.
Since the controller motor board has 3 power supply: 1) Console 2) Main Motor 3) Incline Motor.
LED Blink Patterns on the Control Board Treadmill
Blessing
[email protected]
celular+WhatsApp:+50588611441
Hi sir
Please review if the 1)outlet is Off, put some lamps and test if o.k
2) if is o.k test the c.breaker or fuse in the treadmill.
3) if are o.k See if the Red Led in the controller motor board is ON you must need to open the covert where the main motor is.
4) if the Red Led is ON, and the machine NOT work, test with a Multimeter or DMM, if there are Voltage in the terminal marked: + - are the wires for to feed the DC motor. if there are Not TIME TO replace the Controller Motor board. If there are test the motor you can use battery for a Drill has 18 Vdc.Depend if NOT work repair or replace Main Motor, of course See If the Drive Belt is O.K, or are broken or loose it!!
Blessing
[email protected]
celular+WhatsApp:+50588611441
LED Blink Patterns on the Control Board Treadmill
Dear Sir:
Hi , this is symptom, that Matrix inside of Console is defective
Is time of replacing , someone can do fix it, BUT the problem
if the service man, want to do it.
Blessing
[email protected]
celular+WhatsApp:+50588611441
How to Replace an Elliptical Resistance Motor
of course see if the cables is good, and test the batteries
or connector before and cleaned with electronic contacts cleaner-
test the terminal at motor for 9VDC APROX if there are the motor is faulty, use the DMM.
Blessing
[email protected]
cell+whatsApp: +50588611441
Open the cover from the main motor.
See if the drive belt is o.k ? or is loose or is Bad?
If the drive belt is o.k You must sure, the Feed wires for the motor are very tight from the terminal Control Board Motor, and then use Electronic Cleaner Contact for the Control board Motor. This cleaner make a good job, for cleaning the corrosion, dust or other situation in the board.
If ater cleaning the board , the problem persist, Take out the Brush in the main motor and see if there are o.k-cleaned? or Wear.
Looke for some wires loose in the control board motor, and tight very well. Most of the main motor has thermal switch inside look if the wires are loose? Tight it.
How to Change the Time on FitbitLED Blink Patterns on the Control Board Treadmill