20 Most Recent
Electrolux Guardian Bagged Canister Vacuum Questions & Answers
No suction; beater bar works. Motor does not
This model has a complicated trouble-shooting procedure that needs to be done by an authorized Aerus Electrolux service tech.
This is often caused by a bad relay board or a Triac. However, problems in wiring or swswiches, including the hose wiring.
I stress that this must be done by an authorized Aerus Electrolux service tech.
http://www.aerushome.com/storelocator/
The filter case that sits on top of the vacuum
This is a propriatary part. You will need to get a new filter cover for the vac from an AERUS Electrolux dealer or repair shop. The vac can run in this condition and your filter will be fine.
Bad bag sensor
yes it is very simple to take apart and replace. for screws on the bag door and then it is only 3 wires to pull off of old switch
I need the manual for the Electrolux vacuum
Owner's manual or service manual?
You should be able to get the owner's manual by contacting the nearest dealership or consultant.
Service manual's are only accessible through software downloaded onto franchise computers, and are unavailable in print.
Power cord will not retract
Your cordwinder is broken take it to your local Aerus Electrolux dealer. If you have any additional problems call Liz at 570-326-1731
I have an Electrolux Guardian Canister vacuum.
I strongly suggest allowing a qualified service tech at an authorized Aerus Electrolux store take care of this. The disassembly and reassembly of the tank and cordwinder are tricky and complicated and incorrect reassembly can cause serious problems. Even to the extent of permanently damaging your vacuum, or worse, result in a shock hazard or fire.
I need a new base plate for an Electrolux vacuum
This part is not available through any vacuum parts house / vacuum store. You would have to check your yellow pages to see if there is a local Electrolux dealer in your area. You might also try to find Electrolux on line and contact them that way.
ELECTROLUX C101H JUST SHUT OFF
it does have an internal thermal overload device you need to put the vacuum into the shop they should be able to fix it in a few days
Electrolux Ambassador stainless lower wand
http://geeksquad.fixya.com/ThreadView.aspx?prdid=113654&thid=638738
Electrolux Ambassador stainless lower wand
Posted by Cuyler on Jun 01, 2008
I am trying to locate a stainless lower wand for an Electrolux Ambassador model 1623. The search has proven fruitless so far. Any suggestions?
Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. A couple of thought came to mind that you can try. Look in the yellow pages for your local vacuum dealer to see if they carry it to contact your Electrolux factory @ the phone # listed below. So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.
http://electrolux.com/ Customer Service 1-800-896-9756
Electrolux Home Care Products – North America
P.O. Box 3900 Peoria, IL 61612
http://www.a-1vacuum.com/ 1-800-657-1874 Customer Service
Thanks, Don the Vac Man
Go Ahead. Use Us.
Electrolux canister C104A: Unit shuts itself off
I have a similiar problem, but LED light does not flash. I have determined it is a short in the hose wire. THERE ARE NO REPLACEMENT PARTS FOR THIS MODEL OF ELECTROLUX. I'll never buy another Electrolux product.
Not finding what you are looking for?