20 Most Recent Hotpoint Ariston Aquarius WD420 Front Load All-in-One Washer/Dryer Questions & Answers

0helpful
1answer

Machine does not seem to be filling properly, then does nothing else.

Sounds like you're fill valves are junk which sadly happens allot. This video is very generic but should give you an idea
7/6/2017 12:35:23 AM • Hotpoint Ariston... • Answered on Jul 06, 2017
0helpful
1answer

WD420, drying high heat, time saver and ON/OFF

this usually means that the main pcb has a corrupted eprom or eprom memory has been wiped... you either need a new pcb with eprom or a new board pre-programmed.

hotpoints terms for error

Setup error: check eeprom
F09
Flash
OFF
OFF
Flash
OFF
6/28/2017 12:53:24 PM • Hotpoint Ariston... • Answered on Jun 28, 2017
0helpful
1answer

Anyone now the fault light codes for this model---thank you

Flashing Lights & Error/Fault code - Repair

www.how-to-repair.com/.../washing-machine-with-all-the-lights-flashing...
Oct 25, 2014 - Now there may be some variances for older models, but there are 3 main types of board listed ... Tagged under: Ariston, Creda, error codes, flashinglights, Hotpoint, Indesit ... And can someone please enlighten me, thank you.

Identifying Hotpoint or Indesit Error Codes - YouTube

? 6:46 https://www.youtube.com/watch?v=aud14I0Zu9M Aug 29, 2014 - Uploaded by eSpares If your machine is stopping with flashing lights or a error code on the ... Lights on Washing Machine How to Repair Hotpoint,Ariston, Indesit ...

Flashing Lights on Washing Machine How to Repair ...

12/29/2016 2:11:28 PM • Hotpoint Ariston... • Answered on Dec 29, 2016
0helpful
1answer

Washer/dryer has completed two cycles and the door won't open

The door lock mechanism is stuck. You will need to get access to the back of the machine in order to undo the screws holding the top of the machine on. Make sure the machine is unplugged from the pains supply, there are wires attached to the switch and they may be live. Remove the top of the machine and reach down inside to where lock is (near door handle on front), push on the back of the lock/switch and it should release. If the problem re-occurs then the lock/switch will need to be replaced.
5/3/2016 12:36:55 PM • Hotpoint Ariston... • Answered on May 03, 2016
0helpful
2answers

All lights flash when started

try a different socket and try not to use extension leads if the lights continue to flash do not worry for now . the balance problem could be uneven load . or get some one to remove top and check support springson top and dampers at bottom are still in place . and concrete weights are not loose .
12/20/2015 1:22:53 AM • Hotpoint Ariston... • Answered on Dec 20, 2015
0helpful
1answer

How do I turn off the time saver option?

You should just be able to press the button. Has the machine stopped working with the START light flashing and the time saver light on? If so, this is an error code indicating a motor fault. Please describe any other lights that are on and if they are flashing or solid
9/21/2015 8:06:28 PM • Hotpoint Ariston... • Answered on Sep 21, 2015
0helpful
1answer

How do i find the wiring diagram for the side circuit broad

is it the motor control board ure asking about
4/5/2015 8:14:31 PM • Hotpoint Ariston... • Answered on Apr 05, 2015
0helpful
1answer

Hotpoint wd420 shows error code f13 after replacing heater element for dryer.

Change electronic board it is what will cause this problem if you checked all ducts an fan and still heats board is bad
3/24/2015 1:13:48 PM • Hotpoint Ariston... • Answered on Mar 24, 2015
0helpful
1answer

How do I remove the back panel off my hotpoint wd420 washing machine

should b screws holding back on
2/22/2015 11:08:34 PM • Hotpoint Ariston... • Answered on Feb 22, 2015
0helpful
3answers

Need Manual for Frigidaire Gallery Heavy Duty Washer/Dryer Combo Model #FLSG72GCS0

my washer make a loud sound when spinning
1/12/2015 7:48:45 AM • Hotpoint Ariston... • Answered on Jan 12, 2015
0helpful
1answer

What can be causing my washing machine making roaring sound during spin cycle

Could you have lost a coin or something else out of a pocket that has found its way into the motor.
6/29/2014 5:34:56 AM • Hotpoint Ariston... • Answered on Jun 29, 2014
0helpful
1answer

My nob on the dryer is broken how can i find a replacement? It has a crack on the inside

Keep a look out for hard rubbish, I found knobs for my gas heater someone was throwing a model that was not the same but close, and they work.
4/15/2014 11:45:32 AM • Hotpoint Ariston... • Answered on Apr 15, 2014
0helpful
1answer

My front load dryer the knob to turn it on is cracked inside how do i get a replacement for it?

You can order one online from any number of appliance parts sites, such as ereplacementparts.com. Enter your brand and model number, then pick out the part you need from the displayed illustration. If you live in a larger metropolitan area, then find a local appliance parts supplier in the yellow pages.
4/15/2014 5:50:45 AM • Hotpoint Ariston... • Answered on Apr 15, 2014
Not finding what you are looking for?
Hotpoint Ariston Aquarius WD420 Front Load All-in-One Washer/Dryer Logo

207 questions posted

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

Jesse Garza

Level 2 Expert

84 Answers

Lawrence Oravetz

Level 3 Expert

10558 Answers

Cindy Wells

Level 3 Expert

6477 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Hotpoint Washing Machines

  • Hotpoint Washing Machines

Most Popular Question

find

  • Washing Machines
Loading...