Top 20 Kenmore Elite Oasis 27052 Top Load Washer Questions & Answers

Washer Not working at all Symptom Diagnosis Sears PartsDirect The page has tips on what might be the issue. You need the whole part number like 110.27052600 and it could be expensive to repair.

I would think the lid would unlock once you unplugged the machine. Check your owner's manual for any kind of "emergency reset" procedure. Perhaps the lock mechanism is jammed. Have you tried pressing on the lid or tapping it to see if that frees the lock?

Probably tub bearings are worn. You can also take Pump off and look to see if any obstructions are there.

I would still replace the suspension rods and bushings. Not much else it could be if machine is level and clothes are distributed evenly. I also have seen the cabinet weld separate at bottom, so be sure cabinet is secure.

sounds like a gearbox oil seal,which are not normally replacable tie to replace it

if this is an oasis model. Try pushing other buttons you should get a touch tone (beep) as a good response. if no sound you seem to have a interface problem. not a main ctrl.

If not during a wash it is standing water. Remove tube and check for cracks. If so, replace. Does/did the washer "walk"? May have rubbed the discharge tube and caused the leak. Is the down pipe in a cold external wall? May be condensation from humid air hitting cold. If the sound is the problem, attach a string to the drain pipe so water drips directly to side of vertical pipe.

Change belts

Depending on the age of the washer most modern appliances cost more to repair than they are worth. Your problem sounds like more than a simple filter. I suggest unplug it, dip the water out of it with a quart cottage cheese cup, then recycle it and purchase a new one.

Try wd40

Here's a good video that shows you step by step: https://www.youtube.com/watch?v=Nx6tJnyAi0Y

Dump the appliance. sears delivers the worst garbage available

I surely wish I had good news, but most likely you will have to find & pay someone to completely dis-assemble the washer to do this. If you lived in my area of Florida, I would send you to an older man who knows all there is to know about Kenmore (Whirlpool) washers, and he could tell you if is possible. Do you have anyone in your area who you could ask? Specifically, someone who is older, experienced, and works out of their garage, or small workshop. God bless your efforts.

Carol, that is a little much, mechanism that contorl pump may need adjusted. To show your appreciation press the helpful button and follow me on fixya for more tips and info

Have you put too much washing in....pushing against the door mechanism??? Reduce the amount of washing...see if that works..

my washing machine leaks water onto the floor during each spin ...

https://answers.yahoo.com/question/index?qid... Feb 3, 2010 - During drain and spin only A washer that leaks only during the spin cycle often has a leak in the main drain hose. ... It happened to us due to over loading. ...something can get betwen the two tubs it this all fails your tub seal is ...

Sorry F1 is a fatal error with the main control. You'll have to replace it or buy another washer

Hello. The error code means there is a problem with the door lock. The lock *may* be working correctly but the main board is not getting the indication of lock position(open/closed). Or, the lock may have failed completely--when you initiate a cycle, do you hear the lock engage? Is the door, in fact, truly locked? The lock is really just a simple electro-magnet. When energized, it magnetically pushes or pulls a lever so you can't open the door. Also, it contains the ability to let the main board know when it's safe to start the wash cycle. I hope I helped you!

You may have a bad water valve,could be over filling. But. Still could be a drain pump. Does the tub ever fill with water when you are not using? Also too much soap and not using HE. Soap. Can cause this