20 Most Recent
Questions & Answers
Contractor and Plumber left transport rods in
it seems that your washer isn't seated properly. I don't know what type of machine you have but if you could let me know I might be able to help you with your problem. Usually with top loaders you just put your hands on the back of the machine and lift forward toward the front and that should seat your machine but not knowing the type I can't be sure.
on Feb 03, 2018
Which hand sanitiser are the best ?
Unfortunately Enaya Sharma is just a cheap scammer adding spam to the site and trying to sell sanitizer that is not good for the skin. The best ones contain alcohol, but her religion forbids the use of alcohol. What she is selling, a whole 15ml is Quaternary Ammonium Compound, short named a 'QUAT Sanitizer'. It is not recommended for the skin and is only for hard surfaces.
9 hours ago
Trouble shooting. No water in the washing machine Grundig GWN 48430 CW
This is the first time I have heard of a washer under the Grundig label - hopefully they aren't as complex and over-engineered as their original products.
Possible causes of no water in tub...
Failed water inlet solenoid valve.
Failed tub water level switch or blocked tube to the switch (if your washer uses a pressure switch to control level.
Door switch or wiring.
How do i replace door seal on a DWD-FC 1241A
Dwd-L142KC has a direct drive motor. A very common fault on this machine is that the drum shaft seal fails, letting water into the bearings which then starts to rust and then develope severe play between the drum and the tub. As the stator is mounted onto the tub and the rotor is mounted onto the drum shaft the rotor can then, due to the worn bearing, move too far away from the stator. Because the sensor that detects the actual speed of the motor is mounted onto the stator assembly, the control PCB then no longer gets the feedback signal from the sensor hence the motor not running correct. You'll most probably see the motor only moving in short bursts, a the missing feedback prevents it from accelerating further. A bearing and seal repair will in this case resolve this problem. It did on my machine. If the shaft is heavily worn below the shaft seal, this will need sorted in order to prevent the new seal from getting damaged or wearing out to soon
on May 24, 2020
Not finding what you are looking for?