20 Most Recent
Canon iR 2022 Printer - Page 6 Questions & Answers
System error E007
problem regarding fixing unit, Either your fixing film is damaged or the white spot on the film is dirty. You can clean the white spot. If the film is broken, replace the film unit
Scanner is offline
confirm that the
that means there is no communication between scanner and PC. try to double check your connection and if ok, re-install scanner drivers.
regards
My canon iR 2022 is
Canon fuser technology is hp laser printer system.This copier has a fuser film or eleventh cover.Some times its torn or short then this machine say E007.Its an error code.When occurred this E007 you should defective film.
Not able to connect
hi friend
please cheak your usb data cable of printer is it working propely or not if its working fine then use the another port of your computer might be your computer usb port has been not work properly
best luck
MY CANNON IR 2020 IS
The Fuser film in the Fuser Unit may be teared off. Try replacing the Teflon Sheet.
My xerox machine cannon IR
Hi
you need to reinstal the firmware on your machine, And for the E007
check if the new film is rotating in the same speed as the presure
roller, check if you mounted the film sensor corectly, and if the sensor
is reading the corect end of the film ( it schould be the one whit a
white square on it).
Pls vote me to keep me alive
Canon IR2020 Disply showing "System
Hi,
these means that the fixing film in copier fixing/heater section is worn out, and the copier is unable to recognize fixing film.
The solution is to change the fixing film - call service!
Also see the : http://www.fixya.com/support/r5454403-canon_ir2016_2020_error_codes
Connected to pc
Enter service mode * 2 8 *
Under clear, select all and ok
OFF/ON
Should work
Not finding what you are looking for?