20 Most Recent
Goodman CKL24AR24 Air Conditioner - Page 6 Questions & Answers
1 Answer
HORRIBLE NOISE!!
call tech or installer and check condensor fan assuming noise is outside. shut down outdoor unit and hand spin the fan blade to see if it is rubbing
Goodman...
|
Answered
on Aug 09, 2009
1 Answer
I have a Goodman mini-split system with a remote
How far from the unit or room do you have the remote? remember the remote is the sensor, if it isnt near the unit it will not shut off! place the remote 8 feet from the unit and leave it there, if it doesnt shut off, it was installed wrong or is malfunctioning!
Goodman...
|
Answered
on Aug 06, 2009
1 Answer
Changed the compacitor unit ran fine for half a
if you let it thaw it sounds like your coil froze up
a frozen coil is usually due to lack of air flow (a dirty air filter or bad blower motor) if both of these are ok then you probably are low on refrigerant
i would suggest finding someone who specializes in goodman or someone who is certified to handle refrigerant to check your refrigerant pressures
Goodman...
|
Answered
on Jul 29, 2009
1 Answer
The model number as listed on the receipt is CKQ24
Personally I would get an exact replacement capacitor same voltage rating and microfarud rating. The capacitor will read something like 370v 5uf. I would be surprised if that's not the whole problem. If not it needs an exact evaporative fan replacement, and the new Capacitor. Happy cooling!
Goodman...
|
Answered
on Jul 17, 2009
1 Answer
2003 vw passat air cond blows warm air
Hi there. You have a freon leak in the system. You can charge the system and use soapy water on all joints to find the leak. If a slow leak, just recharge every year. This will get you by till you get the leak fixed.
Thanks
Paul
Goodman...
|
Answered
on Jul 11, 2009
1 Answer
Fan would not run , so i diconected the breaker on
Sounds like te start capacitor is defective turn power off and mark the wires exactly like they are on the capacitor. Some capacitors are dual meaning they start the compressor and fan together. But if the fan side is bad it will try to start and after too many attempts will damage the fan motor. Let me know if I am helpful or if you need more assistance. Sea Breeze
Goodman...
|
Answered
on Jul 11, 2009
1 Answer
Vw passat air condining not blowing cold air
It's very possible that the fan itself is bad - relatively common on VW's. First check the fuse for the fan on the fuse panel.
You could also have a fan control module problem. Can you hear/feel the compressor turn on? If so, then the module is good and you probably have a bad fan or a blown fuse.
Goodman...
|
Answered
on Jul 10, 2009
1 Answer
Fan Literally came of AC unit! Please help
Maybe. Shut of power to outsde unit. Remove screws holding the wire shield on top in place. You may need to unhook wires to motor. may or right down where they came from. Turn top upside down after removing fan blade from bottom. Check and make sure blade didn't puncture coil. if the hub is still attached to blade you should be able to slide it back on shaft. try to get it back where screw marked shaft and tighten it back in place . some times it it hard to get screw tight if it is on the motor side but you need it tight. Some times a 1/4 inch extentsion turned backward works . Put a wrench on socket end. If hub is broke off you will need a new blade. Becareful not to bend blade as this will cause it to shake when it runs. If this motor was replace recently the company should fix it for free as it was no tightened correctly.
Goodman...
|
Answered
on Jun 30, 2009
1 Answer
I am not getting cold air inside and I have a
You have iced up your unit. Turn Tstat to off fan to on. This will thaw unit in a couple of hours. NOW The reason for the ice up condition has to be found. Low on gas,stopped up filter,stopped up evap.(inside) indoor fan inop. Start with simple first check filer,If you can see the evap coil see if it is stopped up. To charge the unit if low on gas you have to call a service tech. Ask for free estimate so you will know up front what it will cost. Remember if you add gas there is a leak. Make sure your tstat setting is not to low. If the evap coil is dirty you can clean this yourself. Use a stool brush with soft fiber. spray with 409 let soak and brush clean your coil. Rus
Goodman...
|
Answered
on Jun 27, 2009
Not finding what you are looking for?
