20 Most Recent Wurlitzer Jukebox 1015 One More Time 100-Disc CD Changer - Page 7 Questions & Answers

Switch K7. It clicks and stops the motor when the gripper puts the CD back. Either the bracket which clicks it has come loose or the switch doesn't work anymore. (and it's a PIG to change!) K7 is labelled and is the far side of the gripper gears.

Which lights aren't working? Depending on which lights aren't working, I can help you troubleshoot. Please email [email protected].

You can get parts for One More Time at www.wurlitzer.co.uk

Bad drive belts.
Motor needs servicing (most likely).
Hasn't been converted for 50 Hz.


Dave F.

Hi,

The problem may be in the power supply, it could be dry (cold joints in the USA) joints that are giving you problems. If you have the manual try checking the voltages at the power supply before and after you get the problem. It could be that once the jukebox is aired that the problem starts.

Regards
Alan Hood
ami-man
UK

You do not tell us what laser assembly you need. It could have a KSS number or other number. Check with MCM Electronics to see what they have. It might be just what you need.

That usually means the Laser can not pick up the CD surface. I have not worked on Wurlitzer CD but have worked on hundreds of other units and the technology is the same. It could be the platter distance is too far from the pickup or that one of the six laser pickup has burned out to allow correct tracking. There is a Focus OK signal that has to be satisfied first, then spin up and data reading of the TOC. f it can not do that they may spin wildly.

If it is a simplex mechanism then when a selection is made a small 'pin' pops up. The machine then sets going and an arm sweeps round until it bumps into the pin and then goes into the play cycle. The arm is stuck up against the pin because it hasn't reset and so it plays over and over.
Have a look on the right hand side, below the mechanism base board and you will see the circular solenoid selection assembly and the arm that sweeps round. Press the pin back down that is against the sweep arm and it should start working.

Dave F.

Manuals Oline.Com ,You might be able to find one for it on there,

Get a new motor for it, It,s that simple,DAAAAAAA.

The fault is one or the other unit unless you have some sort of physical drag on the CD. There is a problem playing copy CDs too. Some work some dont.

It's a faulty laser unit.