20 Most Recent Haier HDP18PA Stainless Steel Free-Standing Dishwasher - Page 7 Questions & Answers


Hi

If there is no hot water then the issue can also be with either of the two thermostats located inside the bottom panel. If they test fine then it is the heating element that should be replaced. You can also check this video for more help on replacing the heating element:


Hope this helps...please post back for further assistance.
Daniel

Haier... | Answered on May 18, 2011


most likely your door switch is faulty check this first if it is ok may be the electronic board it may have to be replaced let me know how you went remember to turn of power before you open panel

Haier... | Answered on Apr 07, 2011


Hi, I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works like new... However I have also foundthat if the heating element goes bad then that also can mess things up bad...So I would buy new spray arms, and also check out the heating element to makesure it is working... Here is a tip that will help you with the onlinebuying...
Dishwasher SprayArms not Spinning

How to Buy ApplianceParts Online

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The HeatingElement not Working

DishwasherMaintenance DishwasherResidue and Film on Dishes

heatman101

Asker's Testimonial "explanation very clear. will give it a go and see howsimple it was. thanks Ronnie " - ronnieshomes

Haier... | Answered on Apr 02, 2011


1st place I would look is to turn off hot and cold water going to washer,remove hoses and check screens there are usually 2 screens 1 in each connection on washer they pull out and then you can see if they are clogged with debris.After cleaning them make sure you put them back in so that they can protect your washer.

It may also be a good idea to replace those rubber washers in the hose at this time if you haven't in a while for they will leak sometimes if they are old and have been messed with .

Haier... | Answered on Feb 20, 2011


sounds like something is in the sump look in the bottom of the dishwasher under bottom rack and make sure there is nothing in it

Haier... | Answered on Jan 28, 2011


What model is the dishwasher? Please explain. Thanks!

Haier... | Answered on Jan 19, 2011


Have the same problem with mine and have found no solution in the manual or web. four lights flashing and beebs ten times every ten seconds, water coming in and draining out constantly, very frustrating!

Haier... | Answered on Jan 08, 2011


Hi,


Here is a tip that will help you to find out why water will not come into the dishwasher...

Dishwasher Trouble No Water entering Dishwasher

heatman101
..

Haier... | Answered on Nov 12, 2010


Hello. Do this:

1) Shut off the dishwasher and wait few seconds.

2) Turn on the power again by pressing power button.

Press Start/Pause button. After few seconds drain pump will come on

for short period of time twice. You will hear some type drain pump

noise in the dishwasher. Observe if the drain hose is pumping water out

in to the sink.

3) Immediately turn off the dishwasher after the second drain.

4) If there is still water left in the dishwasher, repeat first three steps again
until the water is removed completely.

Haier... | Answered on Oct 03, 2010


Hi there,

Well first of all you can check out the water-inlet valve -most cleaning problems are caused by the dishwasher not getting enough wash water, so the water-inlet valve is often the cause. This valve is usually at the bottom left or right of the dishwasher, behind the lower access panel. It's the device with the main water line from the house, a rubber tube to the dishwasher, and two wires attached to it. When a water-inlet valve is defective, you may hear the sound that's usually referred to as "water hammer." If the water-inlet valve is defective, you need to completely replace it. Further you can check the drain valve - Some dishwashers have a valve (or gate) that should open only during draining. If debris lodges in the valve, it can't close properly, so water drains out during the wash cycle. Most dishwashers drain into the garbage disposer. If yours does that, listen for water flowing into the disposer during the wash cycle. If you can hear it then, the drain valve may be clogged. Please post details about the model number of your dishwasher for further help or information.......

Good Luck!!

Thanks

Haier... | Answered on Jun 28, 2010


Hi there,

Well first of all you can check out the door switch - The door switch is important because, if it's defective, the dishwasher won't work at all. To reach it, you need to remove the control panel cover, or sometimes the interior liner of the door. If it's defective, you need to completely replace it. Your switch also may be locked in place by a locking clip. If this is the case there should be a button or a lever that you can press or pull, which will release the switch and it can simply be removed. Please post comments for further help or information........

Good Luck!!

Thanks

Haier... | Answered on Jun 07, 2010

Not finding what you are looking for?
Haier HDP18PA Stainless Steel Free-Standing Dishwasher Logo

64 questions posted

Ask a Question

Usually answered in minutes!

Top Haier Dishwashers Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Brad Brown

Level 3 Expert

18562 Answers

Peter

Level 2 Expert

202 Answers

Are you a Haier Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Haier Dishwashers

  • Haier Dishwashers

Most Popular Question

hdw101ss not heat water

  • Dishwashers
Loading...