20 Most Recent Stanley Fatmax Xtreme Retractable Utility Knife - Page 9 Questions & Answers

can the battery be replaced. If so, how?
open the cover on the back of the device. this is done by squeezing the cover of the battery sector slightly. then remove the old batteries and replace the new ones (I assume you have the AAA) and put the new ones in keeping with the polarity for the device to work properly and then close the battery compartment cover in reverse order

Measuring Tools... | Answered on Sep 29, 2019

replace the batteries and bring the two units together for a while to relearn

Measuring Tools... | Answered on Sep 18, 2019

Battery compartment contains reset button. Press. Will need to re-enter time and date.


Measuring Tools... | Answered on Sep 10, 2019

Place your remote temperature sensor and the inside unit together for about an hour to see if they both read the same or if there is a large difference in the temperatures.

Dashes on the outside temperature reading may indicate that the inside unit is not receiving a signal from the remote. Change the batteries on the remote or change the location of the inside and/or outside units so that they can receive a strong signal between each other.

Your smartphone temperature may be coming from a location that is not near your home. They are often from a weather service. Where is your local temperature sensor located? Is it in the sun? Is it on the south side of the house, or another location where the sun or an air conditioner or other heat source may affect the accuracy of the reading? Try to locate your outside sensor in a shaded location with plenty of ventilation, and away from heat sources.

Measuring Tools... | Answered on Sep 07, 2019

Do you have a setting for the power line frequency? Some devices get their timebase from the power line frequency and if your powerline is 60 Hz, but you have it set on 50 Hz, then it will speed it up because of the 10 extra cycles per second.

Measuring Tools... | Answered on Sep 07, 2019

The sensor should flash briefly when you put in good batteries. Afterwards it should flash about every couple of minutes. If you have a voltmeter check the batteries are at least 1.3 volts (the voltage will drop when they get colder). Ideally they should be about 1.4-1.6 V. Try cleaning the battery compartment contacts and springs with a cotton bud and alcohol. If the contacts look rusted then use fine emery paper or scrape with a screwdriver to remove the rust and tarnish. Clean the ends of the batteries by rubbing with a tissue or cloth. When inserting new batteries twist them inside the battery housing to help make better contact. Another thing you might try is to use a screwdriver to very carefully stretch the springs in the battery compartment a little to allow better contact. (Warning do not pull the spring too hard so as not to damage it) If using new batteries does not help then the sensor may have a fault. If the led on the outdoor sensor is flashing but the indoor sensor does not pick up the signal you can try putting the indoor sensor closer to the outdoor sensor. Otherwise you may need to re-tune the indoor sensor to the correct frequency (there is a small adjustable screw inside).

Measuring Tools... | Answered on Aug 31, 2019

last four of phone no.

Measuring Tools... | Answered on Aug 24, 2019

Not finding what you are looking for?
Stanley Fatmax Xtreme Retractable Utility Knife Logo

41 questions posted

Ask a Question

Usually answered in minutes!

Top Stanley Measuring Tools & Sensors Experts


Level 3 Expert

85239 Answers

Lawrence Oravetz

Level 3 Expert

10548 Answers

Frank Walton

Level 1 Expert

26 Answers

Are you a Stanley Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Stanley Measuring Tools & Sensors

  • Stanley Measuring Tools & Sensors

Most Popular Question

just purchased stanley fatmax 10 778

  • Measuring Tools & Sensors