20 Most Recent Black & Decker Black And Decker 2 Million Power Series 1365 Lumens Spotlight #VEC157BD2 Questions & Answers

0helpful
1answer

Can you charge a sl1028 with a stander 120v AC

Asuming it is the right connection, you have to check the polarity and a page is correct, then yes
10/29/2013 12:27:08 AM • Black & Decker... • Answered on Oct 29, 2013
0answers
0helpful
1answer

Need charging instructions for black & decker

Hello. Use an ordinary extension cord and plug it into the back of the light and into the wall. Charge it for 20-30 hours, but not more than 30 hours. Here is the downloadable manual for future reference
http://demandware.edgesuite.net/aaea_prd/on/demandware.static/Sites-black-and-decker-Site/Sites-cpo-master-catalog/default/v1269899899597/dw_manuals/black-and-decker/bdknvec157bd/bdknvec157bd_manual.pdf
3/29/2010 11:11:12 PM • Black & Decker... • Answered on Mar 29, 2010
0helpful
1answer

Will not charge or luminate main light

the small lights on when you switch?Try to switch the small lights together with the main light at the same time..If the small light will off when you switch the main light is meaning that the batery is too weak.Thus you need to charge,but your one problem is that it doesnt charge?Check the wire if it has cut or loosen connector.Most of the problem about charger is the wire itself due to a regular shagling or moving during a charge will perform.If the wire is good,next to check is the fuse.,Finally,if all these mention parts are good,you must check the Rectifier Diode if it is shorted.If not,then you need to replace the batery because the problem is that it is not charging,but it is not storing a power on your batery.
On the other hand,,if at the same time you switch the lights and the small light is still on but the main light is still doesnt work: check if there is a fuse and see if it is open,or check the main bulb itself because maybe it was opened too?
11/5/2009 3:55:06 AM • Black & Decker... • Answered on Nov 05, 2009
0helpful
1answer

CHARGED THE BATTERY AS INSTRUCTED, UNIT DOES NOT WORK

check the factory date.. the batt might be bad due to time, check the polarity conexion to the batt might inverse. i suggest u try another batt..
3/15/2009 11:43:27 PM • Black & Decker... • Answered on Mar 15, 2009
0helpful
1answer

How do i calibrate a black & decker BDL220S laser level

Rotate the laser to center horizontal (H) or vertical (G) bubble vials
9/11/2022 3:59:12 PM • Black & Decker... • Answered on Sep 11, 2022
0helpful
2answers

I have a BDS 300 sensor and have lost instructions

I just bought one too and instructions need deciphering. Select wood or metal with selector switch. Put unit flat against wall. Press and hold on/off button on left. (It looks like it must be kept pressed in at all times to be 'on' and when released it's 'off). The unit with calibrate and give a beep back and lower red LED will stay on. Move unit slowly left/right and more red LEDs light up until green is on. This is 1st edge. Mark it with pencil. Move unit along until Green is off and down to single LED. Then move it back in opp. direction until Green is on again. This is 2nd edge. Attached is a scan of page from Instruction Manual. Quality is lowish as attachment limit here is 150kb.e4edea4.jpg
1/29/2013 10:11:15 PM • Black & Decker... • Answered on Jan 29, 2013
0helpful
1answer
0helpful
1answer

I have no laser light when I turn my level on

Check to make sure battery isn't bad first.. If upon changing the battery, it still doesn't work, the laser might be bad or worn out. Good luck... HDTV GURU JAY
3/16/2011 1:51:44 PM • Black & Decker... • Answered on Mar 16, 2011
0helpful
1answer

CHarging light blinking while trying to charge

Battery is old...time for a new one.
9/3/2009 5:12:36 PM • Black & Decker... • Answered on Sep 03, 2009
0helpful
1answer

I have a Digitech XC0436 Weather Station.

Remove the batteries from both units for a couple of hours. Replace the indoor unit battery and then the outdoor battery. This will effect a reset of sorts. Don't forget your rainfall can be different to someone 600 meters away. Having said that 100mm / 4 3/4" difference is a lot.
1/28/2023 11:26:55 PM • Measuring Tools... • Answered 3 days ago
0helpful
1answer

Envirastation dws400 main unit displaying HH for outside temp

How do I get my envirostation 400 to stop beeping or stop changing the channel
1/25/2023 4:59:59 AM • Measuring Tools... • Answered on Jan 25, 2023
Not finding what you are looking for?
Black & Decker Black And Decker 2 Million Power Series 1365 Lumens Spotlight #VEC157BD2 Logo

9 questions posted

Ask a Question

Usually answered in minutes!

Top Black & Decker Measuring Tools & Sensors Experts

Brad Brown

Level 3 Expert

19166 Answers

Tom Chichester

Level 3 Expert

62329 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

55502 Answers

Are you a Black & Decker Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Black & Decker Measuring Tools & Sensors

  • Black & Decker Measuring Tools & Sensors

Most Popular Question

charge sl1028 stander 120v ac

  • Measuring Tools & Sensors
Loading...