Hamilton Beach BrewStation 47214 Coffee Maker - Answered Questions & Fixed issues

First scrub at it with a sponge and some dish soap. Rinseit, and then mix some vinegar with water and run the pot like normal (withoutcoffee) then run it a few more times with just water. Coffee beans that are exposed todirect sunlight or extreme temperature variations may develop enough moistureto allow mold or bacteria to thrive. To prevent this please follow these steps: 1. Pour the green coffee beans intoa clean, dry brown paper bag. 2. Seal the top of the filled paperbag by folding it over twice and crimping it closed. 3. Place the paper bag of greencoffee beans up on a shelf in the basement or anywhere else in the house thatstays cool, dark and dry without much fluctuation. 4. Roast the beans within 3 yearsbefore the coffee beans begin tasting like the bag they are stored in.
Sealing coffee beans into acontainer that does not have the air vacuumed out can create conditions wheremold and bacteria could grow. People in humid environments may consider using aFood Saver or other vacuum sealer to keep green beans dry. Lower the sealedvacuum container into a large brown paper bag to block light.Hope this will help you.Good Luck.

Hi,

To set the timer, please use the steps as shown in the attached images:








For more details, download the complete instruction manual by clicking this link.

Adobe PDF Reader is required to view this manual. Download Adobe Reader
Thanks for using FixYa.

Yes, it works just like a regular coffee machine, like mr coffee, but instead of using 8 or 12 cup glass craft, it makes one cup at a time, put coffee grounds in to your desired strength , put water in container and put cup under and have a great cup of Joe. Thanks Mr Bean

chances are, you're filling the machine up with too much water. look at the water resivoir and see if there's a hole somewhere toward the top or a marking indicating the water limit.
-Bam-
Grape Jelly

Remove the water filter, if you have one. Pour 2 cups of vinegar into the water reservoir. Turn on, wait 20 seconds, and turn off. Leave for 30 minutes. Then turn on, and turn off when finished. After it has cooled, dispense several cups, then empty and rinse the reservoir. Run two or three more cycles with (clean) water only, allowing to cool between the cycles.

put bicarbonate soda salt and vinegar in the water unit and make sure you give it a good clean i could instuct u to use drain cleaner but you might die lol nah only kidding soda salt and vinegar are what is used to clean drains and pipes all u can do is try cant hurt but make sure flush the machine

also have you been flushing it after every use if not theres your problem

Your Use and Care Manual can be found here:

http://useandcares.hamiltonbeach.com/files/840160001.pdf

See page 7 of the pdf for illustrated instructions on setting the clock and programming.

Try poking holes in the little screen over the dispensing hole. That screen gets plugged up. I don't know why they don't sell replacements for these things....

vinagar is great for coffee pots. you run the vinagar through then water to rinse it.

The water level sensor is faulty: either it was corroded or it's covered with the lime that has deposited from the water.
Clean it thoroughly with boiling vinegar - it will dissolve the lime and the oxides. If this doesn't help then , indeed, you need a new pot - you can't replace just the sensor.

The Use and Care Manual for your coffeemaker can be found here:

http://useandcares.hamiltonbeach.com/files/840160001.pdf

Se page 5 for illustrated instructions on How to Make Coffee including how to set the clock and use the auto function.