Yardworks Broadcast Spreader - Answered Questions & Fixed issues


where can I get a new flow control box?

Yardworks... | Answered on Sep 05, 2013 | 1,776 views


Strimmer line is consumed constantly in use either by wear against abrasive surfaces or being snagged against stems and suchlike it can't cut through and so tends to break. With lots of patience a lot of those stems can eventually be cut.

Early strimmer users became fed up with the process of stopping work, upturning the machine and releasing more line and starting over and so in order to maintain sales the bump and automatic feed heads were developed.

You description suggests you are using your low powered grass trimmer for heavier work than it is designed for.

Garden | Answered Yesterday | 17 views


Look between your legs!

Garden | Answered Yesterday | 414 views


all 2 strokes take a 50:1 mix. Thats 2.6 ounces of 2 stroke oil, to 1 clean unleaded gallon of gasoline.

Garden | Answered on Jun 25, 2020 | 17 views


It could be a weak spark but most likely it is not receiving the fuel it needs for full throttle operation.

Assuming the fuel is fresh and there isn't an excess of oil this can be tested to some degree by opening the throttle fully and then partially applying the cold start if it can be applied separately or partially covering the intake of the carb with a finger if it can't.
If this improves things it proves the mixture is too lean and it could be a blockage or a matter of adjustment.

One thought occurs - if it was ok before being idle over winter, it is possible the crankshaft oil seals have lost flexibility and air is being drawn past them into the crankcase.

Garden | Answered on Jun 24, 2020 | 34 views


Trigger available on this one stripped down for parts

https://www.ebay.com/itm/Black-Decker-Belt-Sander-7451-TYPE-2-Parts-Sold-Individually-Or-As-Part-Group-/183926335324#viTabs_0

Trigger & Power Cord : The trigger worked well and there should be ample wire left to tie it into your motor. The cord itself has a lot of damage and tape repairs, but I let it be so that the collar and other parts can be used.

Or the other thing you could do is bypass the switch, fill the hole with epoxy putty and put a sliding light switch in the cord near the sander tail.

https://www.amazon.ca/uxcell%C2%AE-Inline-Switch-Toggle-Table/dp/B07P5YW8TG

Garden | Answered on Jun 24, 2020 | 16 views


fixya doesnt sell products --try manufacturer or online search using make and model

Garden | Answered on Jun 24, 2020 | 23 views


bad battery
not enough to run the ignition and the starter but enough when the starter is not engaged

Garden | Answered on Jun 24, 2020 | 19 views


it's right in their little black box you can't see it the fuse itself will be covered in dry grass. and stuff so you'll never know it's there. and it has one of these bullet in clips it holds it there.

Garden | Answered on Jun 24, 2020 | 21 views


Perhaps the fluid has become contaminated and is foaming and/or one or more filters is being partially blocked after running a while. Perhaps also the fluid is boiling due to a lowered boiling point caused by contamination.

The fact it is ok while cold is likely to indicate the trouble is related to one or all of the above and so cleaning or replacing the filters and replacing the fluid seems the most appropriate initial action and if the trouble persists the next step will be to check the pump is maintaining the rated pressure when hot...

Garden | Answered on Jun 23, 2020 | 19 views


you need to resubmit your question including what machine you are having the problem with... helps to have a lot of information versus little...good luck

Garden | Answered on Jun 23, 2020 | 19 views


https://www.manualslib.com/products/Yazoo-Kees-Zmbi48180-7105503.html

Pg 20.

Garden | Answered on Jun 23, 2020 | 28 views


the real question here is what is it??

Garden | Answered on Jun 22, 2020 | 23 views


look in the owners manual or call a local dealer

Garden | Answered on Jun 21, 2020 | 18 views


find and download the owners manual..

Garden | Answered on Jun 20, 2020 | 23 views


I would look on u tube

Garden | Answered on Jun 20, 2020 | 258 views

Not finding what you are looking for?
Yardworks Broadcast Spreader Logo

3 questions posted

Ask a Question

Usually answered in minutes!

Top Yardworks Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2481 Answers

john h

Level 3 Expert

23424 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Yardworks Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...