20 Most Recent Hobart HL600 Legacy Stand Mixer - Page 11 Questions & Answers

Baldor no longer manufactures that motor. Hobart would have to install a kit that includes every electrical component in the machine. Be careful if you find a used one, they have a very fragile encoder on the rear of the motor.

It is overcurrent issue due to low supply volt or batch size too big or VFD is faulty.

It is over current issue due to low supply voltage or batch size too big or frequency drive shorted.

Having 9 wires means it is a 3 phase motor. For 220 to 240 Volts - L1, T1 and T7 go together. L2, T2 and T8 go together. L3, T3 and T9 go together. T4, T5 and T6 go together. For 440 to 480 Volts - L1 and T1 go together. L2 and T2 go together. L3 and T3 go together. T4 and T7 go together. T5 and T8 go together. T6 and T9 go together.

Kitchenaid.com

go google and type in--hobart food mixer manufacturer and there are pages of hobartfood.com.au and hobartcorp.com/products/food-prep/mixers / all of these pages will have a contact us section where there will be phone numbers and e-mail addresses contact them direct in a area /country near you and see what is available

images for hobart gwx2 manual & wiring

Id contact Hobart. the serial # doesnt use a date code. Hobart Contact Us

First check- is unit single phase? Check for bad capacitor(s). - is unit three phase? Check for missing leg(s) or bad wiring conections. Next check motor windings and for shorts also if it is mechinal binding up. If motor is good , check for problems in the drive train.

If your mixer's power is three phase, switch any two of the power leads to get it to run, turn the other way

Lora I see lots of the same question from you and notice you are asking in the food mixer category. Might be time to ask in the oven category. Another plan would be to contact an authorised Hobart service agent and see if they can help you. Normally they will have access to service data.

I can't think of any reason why you couldn't. If I had to move it, I would certainly ly it down.

go on line to hobartfood and see if there is a pdf version available

get new gears or shaft as the drive is failed