20 Most Recent Jura Capresso Impressa Z5 Espresso/Coffee Maker - Page 4 Questions & Answers

Message :Fill SystemCauses/Troubleshooting:Leaks in the fluid system-localize the leaks and seal them.Blockage in the fluid system, no water can be fed - Localize blockage and replace blocked components (valves, heater, tubes) if necessary.Flow meter-count error - Open the floow meter by a quarter turn and clean it, replace if necessary.

I took the grinder apart and found to have to replace the two metal grinding tools (inside cone and outside ring.The parts for it were quite cheap. Just get yourself a proper instruction how to do it and follow it religiously. There are marks left by Jura engineers to calibrate the grinder assembly. Changing the actual grinder bits inside does not alter these if put together in the same position. The calibration is essential for a decent taste. After 7 years I would recommend a full service anyway. This will not be cheap, but all seals get replaced or just the brewing unit and the machine will be physically cleaned inside. Only a clean machine will give a decent taste. And the usual cleaning and de-scaling you can do is not enough to maintain a squeaky clean machine over the period of a few 1000 cups of coffee.

Try to snap out the metal contacts on the tray and clean behind them. Make sure that everything has dried up before you reassemble.

Is it a J5 or Z5? Either way, you need to use fresh coffee beans with the coffee machine.Trouble shooting guide is here:Jura Coffee Machine

Hi.

Empty the drip tray, then disconnect power for ten minutes.

If that does not work, then that means that a maintenance procedure was started, but had not been completed.
In that case ensure you do COMPLETE the maintenance procedure below, click on the picture to enlarge:



If still no luck, then the sensor in the drip tray may be faulty, clean the drip tray and eventually call Jura at the number listed on the owners manual to get instructions on how to get repair service.


Regards.

i had this same problem, just unplug the maker and plug it back in then open the tray and close it. that should fix it

Which part of the world are you based? Go to www.jura.com, select which part of the world you are based, and it will take you to a local agent.Otherwise google it

Remove the grinds container than put it in, rinse or power cycle the machine and it will be sorted out.

There are metal connectors at the back, using a dry towel wipe then clean. If you still get the error, than the connectors those connectors connect to have water. The silver connectors get all fusy if there is water on them.