20 Most Recent Kenmore Single Room Air Conditioner - Page 6 Questions & Answers

pls. check re set heat s/w and check heater fuse is open.
set tharmostet adjest
if posibal A/c -heat s/w is not work. or dry canaction.

if you got power to the panel but the button aren't responding you have a blown out circuit board or a busted capacitor.

The thermostat should run at the temperature desired for as long as your setting. If it cuts out early, then in some cases the humidity is causing ICEING (Ice buildup on the coils) and needs to sit for a time until it melts off. A manual override will keep the device in operation, but the cooling is usually the air crossing over the iced coils and entering the house. Factory service will locate the problem.

something got fried.. need to check it out..

first is this a external or internal overload. you will need a ohm meter. disconnect the overload from the circuit and test for continuity. if there is continuity your good if not replace it.

could be that the the contctotaor is bad or the start capacitor is bad

go to www.searspartsdirect.com with your Model and Serial Number, it will give you a breakdown.

Will need more information like the model and serial number to answer this question.