20 Most Recent Kenmore 33169 Gas Single Oven - Page 5 Questions & Answers

Due to the cost of control boards and the problems associated with them, I always advise a service call to replace them. In that way the part and the service provided is warrantied. They keep going until it is fixed. Request to send the board back as faulty and ask them to double check it is the correct board for your service and sub-model. There are 6 sub-models designated by another 4 numbers after the '9420'. https://www.searspartsdirect.com/model/1k9fnm0gf7-000582/kenmore-79094202310-parts ..

HI. follow the procedure below.

1. Disconnect power for at least 30 seconds.
2. Re-apply power and observe for at least one minute.
3. If code re-appears, replace control board (also called ERC or clock).

Almost certainly a burned out element, so test with a multimeter after turning off the power. Could also be; Burned out connectors onto the element. Fuse if it has them. Switch control. (unlikely)

buy new is only fix there is

Question edited for clarity. You need a service call. It's dangerous. The F10 code on a Kenmore oven means that the oven is overheating - the oven is detecting a temperature far over the safe range of operation. Most models also start beeping when this happens since it can be a safety concern.Apr. 14, 2020

How to Troubleshoot Error F10 on a Kenmore Stove ' Hunker

https://www.hunker.com > ... > Other Home Appliances About featured snippets

How To Fix Frigidaire Range F10 Error Code (appliancecodes.com)

When you got home, the meal was destroyed? The latent heat will stay in the oven cavity for many hours if properly insulated around the cavity.

KENMORE C970 USE & CARE MANUAL Pdf Download ' ManualsLib Kenmore Range Stove Oven Troubleshooting & Repair ' Repair Clinic

no reset

WWW.SEARSPARTSDIRECT.COM

defective thermostat possibly

Use a barbeque cleaner.

if voltage to ignitor or heating element replace

Could be temperature control failure

CONSIDER THYSELF LUCKY AS MANY QUIT WORKING AFTER SELF CLEANING IS USED

If the element tests good, the temperature control may be at fault.

An oven that is not heating up and that won't heat up is usually the result of an igniter being faulty for a gas ovens or heating elements for an electric ovens. If both your gas oven and your gas burners have stopped working then the problem is most defiantly with the gas line and will have to be fixed from someone that repairs ovens and stoves.

Thank soooo much Benham!!!!!!! I would give u a hug if you were here in my house. I thought the oven was broken. I only had it for couple of months and it is brand new. I held the broiler button down and it is on (f). My oven is normal again. Thank you very much.

Sears phone number shown in online manual if you want to try calling for assistance. Otherwise, consider consulting a local repair service. https://www.searspartsdirect.com/manual/4up3hcd7ih-000583/kenmore-elite-79048173002-electric-wall-oven

Hello. The closest model to the one you say you have is 79092702011... There is nothing on the sears website remotely close...The elements, if this is the real model you have, are as follows: bake...316505500 Broil...316203301 I hope this helps you...