20 Most Recent Kenmore 53092 / 53094 Side by Side Refrigerator - Page 8 Questions & Answers

All have a pan located under the evaporator core. The drain hole is located at the lowest point in the pan.
Occasionally the hole will freeze up with ice and not flow.
Defrost the fridge for two days and this will usually open the tube. Use care when working with electrical appliances.

Kenmore... | Answered on Oct 18, 2019

Thermistors input temperatures to the control boards. Thermistors may have a 2k Ohms value at 70° F, a service manual or guide, or look up part number for replacing any thermistor out of range.

Kenmore... | Answered on Oct 16, 2019

To have the model number would be very helpful to give you the correct information.

Kenmore... | Answered on Oct 16, 2019


Kenmore... | Answered on Oct 14, 2019

Is there a fan in the refrigerator which draws cold air from freezer. If so is fan working, if fan not working may be faulty fan or thermostat. May also be blocked duct from freezer to refrigerator, only there if fan is used as above.

Kenmore... | Answered on Oct 03, 2019

How doyou change the filter

Kenmore... | Answered on Oct 02, 2019

The bar will sense ice cube level in the holding bin. If it is all the way down it will tell the ice maker to make more ice. When the maker "dumps" the ice the bar should be all the way up and will lower to check the level.

Kenmore... | Answered on Sep 22, 2019

The owner didnt communicate properly.

The fridge worked until it didn't. Unless the owner has tested the unit with a replacement control board and confirmed that is the only issue, it's a guess.

Could be a bad compressor AND control board.

Kenmore... | Answered on Sep 19, 2019

This unit is too new to have a defrost timer. The defrost control is integraed into this board on this model.


Kenmore... | Answered on Sep 16, 2019

The Kenmore 106.9552981 does not have a water filter for the ice maker. Sears Parts Direct has the parts diagram here: https://www.searspartsdirect.com/model/6bcxngyrj2-000582/kenmore-1069552981-refrigerator-parts . The models with a water filter will have the filter in the refrigerator compartment, on the back of the refrigerator or near the middle of the toe kick grill. So I checked the cabinet and refrigerator liner diagrams first. I also used the part search feature on the above page.

I hope this helps.

Cindy Wells

Kenmore... | Answered on Sep 05, 2019

•Make sure that the freezer has plenty of ventilation around it. Some freezers use their outer surface as a heat sink and placing boxes or other objects next to them prevents them from being able to get rid of heat.
•Make sure the freezer is level. Water from condensation needs to be able to drain properly inside the freezer if applicable and having the freezer on an uneven floor can prevent proper drainage of the coils.

Kenmore... | Answered on Aug 24, 2019

I would first check the hose that brings the water from the pipes in the house up into the icemaker make sure that's not leaking. Then I would check all of your connections, Making sure they are good and tight and that there's no holes either in the copper line or the poly plastic line. If all of that checks out fine and you have no leaks there then I would investigate the icemaker.

Kenmore... | Answered on Aug 24, 2019

There are two temperature sensors (one in the refrigerator and one in the freezer). The refrigerator sensor is near the front of the compartment on the right side below the door switch and above the slides for the drawers. The freezer's refrigerator temperature sensor is on the left near the top of the compartment. See the two liner diagrams on the page linked below. To change the temperature, press and hold the Temperature button on the LCD panel for 3 seconds. The display should read the current temperature set point and Refrigerator. Use the Acceler-Ice button to lower the temperature in the fridge. Press the Lock button to raise the temperature in the refrigerator compartment. Press Temperature again to see the Freezer set-point and adjust it as above. Note: the temperature in each part of the unit depends on air circulating from the freezer into the refrigerator. Make sure that the vents aren't blocked. Wait 24 hours after adjusting the temperature set points for the unit to reach equilibrium before deciding if the set point should be adjusted further.

Sears Parts Direct has the parts diagrams for the 106.51139210 here: https://www.searspartsdirect.com/model/4lfq9qfxpx-000582/kenmore-10651139210-side-by-side-refrigerator-parts . This page also has a link to the owner's manual for the side-by-side refrigerator, https://c.searspartsdirect.com/mmh/pd_download/lis_pdf/OWNM/1302214L.pdf . See page 15 of the manual for the information on setting the temperature set-points.

I hope this helps.

Cindy Wells

Kenmore... | Answered on Aug 13, 2019

Not finding what you are looking for?
Kenmore 53092 / 53094 Side by Side Refrigerator Logo

107 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Refrigerators Experts


Level 3 Expert

3063 Answers

Dale Copeland
Dale Copeland

Level 2 Expert

129 Answers

Cindy Wells

Level 3 Expert

6222 Answers

Are you a Kenmore Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kenmore Refrigerators

  • Kenmore Refrigerators

Most Popular Question

door seal between fridge amp freezer

  • Refrigerators