Top 20 American Standard 5 ft Sliding Shower Door - Page 2 Questions & Answers


Trey, motor or pump is seized, have tech. take a look and repair.

American... | 620 views | 0 helpful votes


Be sure to pull the plunger all the way up when diverting the water between the the tub and shower if ti keeps giving you a problem it's faulty

American... | 355 views | 0 helpful votes


It's possible you installed the valve upside down, all values should be labeled in some way marking either hot and cold or it will say the word up where the riser tube port for the shower head is. If that's not the case remove the tub spout and check for any obstruction sometimes during tile or constructing debris can get into the pipe for your tub spout. Lastly the diverter on the tub spout could be bad. Try a new tub spout

American... | 288 views | 0 helpful votes


    1. Turn off the water at the shutoff valve, flush the toilet and hold down the handle. There may be a little water left in the bottom of the tank, but don't worry about it. Wipe the flapper seat with a clean cloth to make sure it's free of debris, and check it for cracks or splits (Image 1).

      How to Fix a Leaking Toilet ' how-tos ' DIY

      www.diynetwork.com/how-to/.../how-to-fix-a-leaking-toilet DIY Network
    Feedback
  1. How to Fix a Leaky or Runny Toilet - This Old House

    www.thisoldhouse.com > ... > Toilets

    This Old HouseA toilet that leaks or runs is an easy homeowner fix-if you know how to diagnose the trouble. ID parts and problems with this handy guide, and hit the hardware ...

American... | 735 views | 0 helpful votes


General Plumbing Supply has always come through for me...

Yelp only gives them a 3/5 but I have always had to wait with PROFESSIONALS to get my turn. I'm not big on ambiance when hunting for obscure plumbing parts..

BRING your old (always... any-parts) seat with you!

Amazon says $34 (plus tax)... Phenomenal return policy

A quick search on line yielded lots of other choices...

Happy hunting!

American... | 1,024 views | 0 helpful votes


The new toilet has more flushing volume than the old one. The system should handle this. The problem could be the vents on the roof are plugged or something in the line is obstructing the flow. You will need to contact a plumber

American... | 692 views | 0 helpful votes


Change the flap in the flush container.

American... | 196 views | 1 helpful votes


This is called air hammer, most times this is caused by vibration when a water pipe is too close to a support board you can put in a hammer arrester or make sure pipes are away from support board .

American... | 236 views | 0 helpful votes


This can answer only by checking the system. Call another plumber.

American... | 109 views | 0 helpful votes


Is the tank cracked or is it leaking from the bolts that go through the bottom? If the bolts are leaking shut the water off, Should have a shut off valve behind the toilet, If not possible around your house. Mine is out by the road where the water meter guy can check it. But shut the water off and put 2 new bolts and gaskets through the toilet. Very cheap fix. under $4.00 USD

American... | 850 views | 1 helpful votes


Your vent stack may be clogged. The pipe that goes up to the roof. Let's air into sewer pipes when you flush. A birds nest or something can do it.

American... | 150 views | 0 helpful votes


The problem may be the flapper that seals between the tank and bowl is leaking or the overflow pipe may have a crack in it. I wouled replace the flapper first and check the overflow pipe for cracks.
Hope this helps.
Bob

American... | 476 views | 1 helpful votes


Hello their is a product called Plasweld,it comes in a handy tube,
Carefully scratch along the crack to allow the weld to come flush with the surface of the shower tray,MUST BE PERFECTLY DRY!
squeeze into the crack and it will find its own level ,this produce actually welds the plastic together
Good builders merchants should stock this item.GOOD LUCK

American... | 100 views | 0 helpful votes


Make sure the water valve to the toilet is actually letting water into the fill valve. Turn off valve, remove from fill valve, run water into a pan to see pressure and confirm water flow. If water flow and pressure good, replace the fill valve.

American... | 135 views | 0 helpful votes


Try using one of these A product called Kaboom Bowel Blaster and let it sit in the bowl for a while, then brush clean. This worked for me when others failed. You can try muriatic acid as a toilet bowl cleaner.Again let it sit for a while then brush and flush available from places like Home depot.Sometimes the toilets are not glazed as well as they should be you might call it a defect I call it poor quality control.

American... | 102 views | 0 helpful votes


remove horseshoe shaped retaining clip. twist stem back and forth while pulling stem. if it still wont come out, you may have to buy a stem puller

American... | 117 views | 0 helpful votes

Not finding what you are looking for?
American Standard 5 ft Sliding Shower Door Logo

9 questions posted

Ask a Question

Usually answered in minutes!

Top American Standard Home Experts

Mike

Level 3 Expert

4369 Answers

john h

Level 3 Expert

23438 Answers

Bill Johnson

Level 2 Expert

306 Answers

Are you an American Standard Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

American Standard Home

  • American Standard Home

Most Popular Question

flair shower door runner

  • Home
Loading...