KitchenAid KEBC277 Electric Double Oven - Answered Questions & Fixed issues

here is my video might help you.

Hi,
Cycling the power off and then on again will sometimes reset it...often you will have to call the customer service number to get the steps to take to unlock that...

Also check out this tip...

http://www.fixya.com/support/r3969401-self_cleaning_oven_problem

heatman101

Yes the inner door glass is a replaceable part and the door will have to be disasembled but not replaced. I can help with sourcing any parts for you since you used a premium post.

Clock error it happens when the external clock goes out of sync with the internal clock nothing to worry about it should have went away on its own after about 30 seconds

Here is the terminal block for a freestanding range, Page 8 onwards. https://www.kitchenaid.com/content/dam/global/documents/201808/installation-instructions-w10694026-reva.pdf https://www.google.com/search?q=kitchenaid+kebc208kbl0+wiring+diagram+pdf I also checked for a Service Manual, but KitchenAid don't release them. ..

Read off the power consumption of each oven and other equipment being fed from the cooker supply and have an electrician check the size of your cooker feed cable and main cooker breaker. If the cable is not thick enough for the oven, you cannot increase the breaker size! The breaker may of course be faulty, measure the current draw as the brealer trips.

Question edited for clarity, the MAKER, and 'what is is'. Question moved to KitchenAid. You may have a bad sensor. Not sure Amazon is the best place to buy. A lot of parts are no longer available, so you should perhaps be thinking of a replacement? https://www.partselect.com/Models/KERA205PSS5/Sections/CHASSIS-PARTS/?ModelID=679473&ModelNum=KERA205PSS5&mfgModelNum=&ManufactureID=3&Selected=N7FWPBQ3&Position=1&mfg=Whirlpool&Type=Range&Mark=1 Is the fan spinning okay? This suggests a bad fan. It has a small circular element around the fan. https://www.google.com/search?q=kitchenaid+keri203pbs+oven+not+reaching+temperature ..

sounds like overheated bad control board or transformer

see if voltege to board

https://www.coastparts.com/lookup/278376

lots of videos https://www.google.com/search?q=replace+the+oven+inner+glass+for+my+Kitchenaid+ykerc507ew2 ..

WE HAVE NO INFORMATION AND SEBSTITUTE PARTS SORRY

Do you have a flame sensor ? As it sounds like the flame sensor is not clean . Or its cracked and not sending a signal back to the spark module . I would also check the connetions are clean and tight .

I have the same issue. Any tips for solution?https://get-mobdro.com/home

Request the Superba model kebc107kss03 manual directly from KitchenAid.

Is it possible you've blown a breaker? Probably a double-breaker, 220V.

the latch the hooks into the door is caught inside the slot where it locks into when in self clean,you have to move the latch,unplug it,look through the air vents or slots up above the door if you can get a screw driver in there try to move the latch or if you can get something down inside to move the latch,i used a plastic long wire tie to do this before,i slid the tie down around the metal hook part of the latch that locks into the door,and pulled it to the left and got the door to open,it got hung up in the hole and the door wouldn't open but what ever works you have to move the hook part of the latch to get the door open,you can try picking up on the door to see if you can get it open or you'll have to pull the oven out and take the top off to get at the latch,hope this helps

In our case, the error code was displayed on a KitchenAid microwave/oven combo. It turned out to be a $4 fuse called the "Main Cavity Fuse". Good luck.

Hello Susan Bailey, Typically "THEY" do... It would be really great to know if we are talking about a USA domestic product... or another NATIONALITY. Other countries normally have FUSES in the appliance cords. Find your MODEL NUMBER and go to a PART/SPARES supplier ( I like appliancepartspros.com ) -> appliancepartspros.com If this is a "MICROWAVE" the FUSE will start popping because the MAGNETRON has deteriorated and is CONSUMING it's own energy. I can be a LOT MORE specific if you provide a model number (pretty please). Read minds... Cannot rally do...!! https://en.wikipedia.org/wiki/Carnac_the_Magnificent

Possible Solutions

Reset power to the product:

There may be a problem with the Oven Appliance Manger Control or the associated wiring.

• Power unit down by turning off the circuit breaker(s) for one (1) minute.
• Power unit up by turning on the circuit breaker(s).
• Monitor the oven for one (1) minute to ensure the error code does not display again.
• Verify oven operation.

Still need help? Call or schedule service.