KitchenAid KERA205PSS Electric Kitchen Range - Answered Questions & Fixed issues

Beth, you either have a failed convection element, part number 9460769, possible bad terminal connection at the element or a failed oven control. A bad element is the most common failure. replacement instructions for a failed heater can be provided.

unplug the unit,then there are 2 screws where the element mounts to the oven body,remove these carefully and pull back/out to expose the connections,then unscrew the connections or remove the spade lugs that the wires hook up to the element,then just reverse procedure to reinstall element and oven

It is easy!! After you remove the two screws pull straight out and do so easily, there are two female spade connectors on the element that you'll have to remove. When removing don't pull on the wire itself,pull on the connector. You may have to use pliers.

This is a very simple repair. The following link explains how to replace the bake element:

http://www.fixya.com/support/r469407-replacing_bake_or_broil_element_in

If you have not purchased a replacement element yet, the part number is 9755770. The cheapest place I could find the element was appliancepartspros.com for about $54.

NOTE: The element may be slightly mishapened during shipping. If you have to straighten the element to install, use care that you do not crack or break it.

If you have questions about this repair, or if you need additional assistance, please let me know. I hope this helps you.

buy a new stove

try unplugging the oven,then plug it back in or try putting the probe in and take it out,if that don't clear it then you may have a bad board

Question edited for clarity and add Maker. Question moved to maker category. Number 1 Tip, never ever use the self cleaning feature. It only exists to break the appliance and create the need for parts and service calls. The temperature is just too intense for the parts. A self-cleaning or pyrolytic oven is an oven which uses high temperature (approximately 932 °F (500 °C)) to burn off leftovers from baking, without the use of any chemical agents. The oven can be powered by domestic (non-commercial) electricity or gas.

Why You should Never Run A Self Clean Oven Cycle & ...

General Appliance Service https://www.generalappliancesvc.com > why-you-shou... Jan 29, 2020 - A self-cleaning oven is a feature on many modern ovens that burns off cooking spills and splatters with an extremely high temperature (932 F° or ... -------------------------------------------------------------------------------------- The only thing suggested is doing a power cycle, but the heat has probably fried the control board which is located too close to the oven and all that heat. https://www.google.com/search?q=KitchenAid+KGSS907SSS00+F3+E3+Error ..

The issue with the oven display light and the oven light on the KitchenAid Stove KERS205TSS 2 may be related. The problem with the oven display light could be due to a faulty control board or a malfunctioning light switch. The control board may need to be replaced if it is not sending a continuous signal to keep the light on. On the other hand, if the light switch is defective, it may not be able to maintain a connection to keep the light on. The issue with the oven light staying on could also be due to a faulty light switch. If the switch is stuck in the "on" position, it will not turn off even when the door is closed. This can cause the bulb to burn out prematurely and waste energy. To fix this issue, you may need to replace the light switch. It is possible that both issues are related and caused by a malfunctioning control board. If this is the case, replacing the control board should fix both problems. To fix these issues, it is recommended to contact a certified technician or an authorized service center for KitchenAid appliances. They will have the expertise and tools necessary to diagnose and repair the stove safely and effectively.

ck this out,,,,, https://www.appliancepartspros.com/repair-help/kitchenaid-range-kgrc707lbs0-repair/kgrc707lbs0-little-to-no-heat-when-baking.html also Repairclinic.com Best to you

The switch that makes it spark?

We are FIXYA dot com, we aren't Kitchen Aid. You error needs a service call, because it probably needs a new control board. These aren't cheap so it needs professional diagnosis. https://www.google.com/search?q=AM71+UI71+EEKGO-010+error+04 ..

Age-related control failure

The element is accessed inside the oven at the rear wall.

That is probably the SAbb code; the Sabbath mode has been set. This mode allows you to heat a meal while fulfilling the "no work" requirement for strict observance of the Sabbath. The oven will stay at the programmed temperature until you change the temperature or end the Sabbath mode. To end the Sabbath mode, open the oven door and press and hold 6 for 5+ seconds. Then close the oven door. Searching Kitchenaid's support site, https://www.kitchenaid.com/service-and-support/manuals.html , I found the manual for the KESC307 ranges here: https://www.kitchenaid.com/content/kitchenaid/en_us/searchresult.html?term=KESC307&tab=clp&plp=&plpView=grid&clp=kesc307 . The direct link to the manual is https://www.kitchenaid.com/content/dam/global/documents/200308/owners-manual-9754287-RevC.pdf . See page 18-19 for the information on the Sabbath mode. You can completely disable the option on the range by following the steps in the manual. I hope this helps. Cindy Wells

Try unplugging for 15 minutes. Then plug back in. That may reset the board. If not, control Board is bad

I didn't see an operator manual using https://www.google.com There were several diagrams and parts lists. An installation manual and a toll free number to call for support is at the link below: https://www.partselect.com/Models/KESH307HBS4/

Have you unplugged the appliance I reset it see if that clears it

Same here. I am in trouble like that. Need to find a solution! Best, http://giaydankinhgiahuy.com/