American Standard 2002.014 - Champion4 Right Height Elongated Toilet Combination - Two-Piece - Answered Questions & Fixed issues


Order flapper assembly directly from American Standard.1-800-442-1902

American... | Answered on Nov 12, 2013 | 244 views


You should be able to replace just the flapper.

American... | Answered on Aug 31, 2011 | 101 views


This could be one of two things. Take the lid off the tank and add a few drops of food coloring and let it set, if the color shows up in the bowl you have what is called a silent leak. aka your flap is bad and only replace it with the exact factory flapper that your toilet came with. yes there are different ones and you will probably have more problems using after market parts.MAKE SURE THAT THE SEAT IS CLEAN AND FREE OF CALCIUM OR NICKS. The other problem although not as common check that the black inlet water tube is above the water line and that the water stops filling apx 1": below top of the white tube that fills the bowl.

American... | Answered on Sep 29, 2010 | 134 views


The controler may be worn or the o-ring gave out. Hope this helps.

American... | Answered on Aug 13, 2010 | 54 views


take off top cover, and check flapper valve for proper seating when flushing.. could be that it is dirty (where it makes contact with tube of tank), and/or the chain length is too short (one link or two)

American... | Answered on Aug 03, 2010 | 104 views


Hi,
Put some cake dye in the tank in the back and you will see it showing up in the bowl....the flapper in the bottom of the tank is leaking very, very, slowly into the bowl....

heatman101

American... | Answered on Jul 23, 2010 | 213 views


flapper needs to be adjusted or replaced

American... | Answered on Apr 19, 2010 | 576 views


Hi,
You have dirt in the supply tube or the valve...
Depending on what valve is in the tank you can take the top off and wash the dirt out...
Otherwise you may have to replace the float valve inside your tank...

heatman101

American... | Answered on Apr 17, 2010 | 137 views


take off the tank cover and you'll see "the flapper" not sealed against the hole where the water goes to the bowl, the chain that holds the flapper might be tangled or flapper is real bad,.....you'll see what the problem is,..

American... | Answered on Jan 19, 2010 | 349 views


Check to see if the chain that pulls the flapper up, is pulling the flapper up far enough. If it is not getting pulled up high enough, the water suction will pull it back down into the hole. You can adjust the length of the chain to remedy this if that is the problem.

American... | Answered on Dec 23, 2009 | 363 views


take the lid off the tank and make sure that the chain is still conected from the flusher handle at the top of the tank to the plug at the bottom of the tank

American... | Answered on Dec 18, 2009 | 220 views


Replace the flappers, and clean around the flapper seat.

Make sure the water level is 1/2 " below the large vertical tube by either bending the float rod down or adjust the skinny silver rod on a Fluidmaster unit.

American... | Answered on Dec 12, 2009 | 501 views


it sounds like your flapper (flush valve) is leaking.
if you here your toilet filling up and no one flushed.
push down on flapper to see if you here the water stop leaking out. if so replace flapper. even if toilet is 1yr or less old. could be a bad flapper. hope this helps. duane :)

American... | Answered on Oct 11, 2009 | 309 views


Yes. You will have to remove your tank from the bowl to replace the defective fill stack(the tube thing your flapper is attached to) it is not as hard as it seems.First remove water supply tube.Then remove the through the tank bolts. should be two of them. Lift off and turn tank upside down. remove spud gasket. Unscrew old stack. You should be able to get a universal kit to work with your tank and should come with all new parts including new flapper and spud gasket. You will need new through the tank bolts and note the sequence of assembly to get water tight seal on tank. Hope this helps

American... | Answered on Aug 03, 2009 | 576 views


you need to replace the flapper, it's allowing water to seep thru

American... | Answered on Jul 12, 2009 | 760 views


The hole your refering to is common in the manufacturing of toilets and is generally filled before it leaves the manufacturing. I have repaired several toilets, new toilets, all American Standard, using a good grade of epoxy - not silicone. I used West System epoxy as this is made for marine projects and surprisingly states "toilet repair" as one of the uses of their product. I'd suggest carefully chipping the smooth porcelan around the hole to give the epoxy something to grip. Use a knife or screwdriver to gently chip the edges and make sure the area is dry. Press the epoxy into the hole and give it enough time to cure before putting it back in service. Of course, if the toilet is less than a month old I suggest returning it and getting a new toilet.

American... | Answered on Jun 22, 2009 | 2,759 views


I would definitely follow your own advise Howard. Good luck

American... | Answered on Feb 03, 2009 | 185 views


I have the American Standard Champion 4 toilet. Water is leaking from the tank to the bowl causing the toilet to refill. I've replaced the flapper and cleaned the surface the flapper contact. Nothing seems to work.

American... | Answered on Jul 02, 2013 | 1,617 views


Depends how old your toilet is, it may be a calcium build up problem on your little inlet pipe inside your tank, but first check your water shut off valve on left side of your toilet near the wall....It may not be open all the way OR the valve has an issue...

American... | Answered on Jul 12, 2019 | 136 views


Hey, One thing is that maybe there might be some loose plastic shavings in the fill line. From the Factory? or maybe was inside the water line going to the toilet when you connected the line to toilet. Shut off the water and get some towels and something to catch the water and disconnect it from the toilet and use bowl or what ever to catch the water and slowly turn it on and see if anything comes out. Maybe if it is in the line inside the toilet it might fall out by lightly tapping on the fill line inside the toilet to help it fall out. Just a thought when you said it "Sings" that sounds like trash inside the line going to the filler tube and bowl, hey try it who knows it might work. Okay

American... | Answered on Jul 12, 2019 | 167 views

Not finding what you are looking for?
American Standard 2002.014 - Champion4 Right Height Elongated Toilet Combination - Two-Piece Logo

22 questions posted

Ask a Question

Usually answered in minutes!

Top American Standard Home Experts

Mike

Level 3 Expert

4369 Answers

john h

Level 3 Expert

23438 Answers

Bill Johnson

Level 2 Expert

306 Answers

Are you an American Standard Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...