20 Most Recent
Krups ProAroma 453-71 Coffee Maker - Page 8 Questions & Answers
How to prime a krups xp 4050 espresso machine
You should not need to "prime" the pump as gravity takes care of it. Check the opening on the water tank to see if in time it has closed up. Check for debris where the tank connects to the unit. If it has a filter, take out the filter and try again.
Krups KM9008 brews SLOW or not at all
If the cold water pumps from the bottom of the unit, you may have a problem with the one-way valve. Normally, this valve opens when the water is hot enough to pump up to the coffee basket, but closes to prevent the hot water from flowing back into the reservoir. If this valve is sticking, that could produce the symptoms you describe. Without actually seeing this unit, I don't know whether the valve itself can be replaced. This may require replacing the whole machine.
My dolce gusto krups machine won't open and allow
We have had this problem twice now. The solution is to drill (yes drill!) through the capsule - a blocked outlet from the capsule itself and the injection of hot water creates a high pressure seal - you have to release the pressure. Do this over the sink - I had hot chocolate spraying about 6 feet from the machine when the pressure was released!! But this solved the problem.
How do i open water resovor on krups oblo coffee maker
See page 8
8
8
FIRST USE
Rinse water tank before first use.
Fill water tank with fresh, drinking water. insert
water tank to machine.
Switch machine on. Power button starts
blinking red while machine is heating up for
approx. 40 seconds. Afterwards power button
lights steady green and machine is ready.
40 sec
ON
Push selection lever to the "HOT" position.
Machine starts rinsing.
Open locking handle and insert empty capsule
holder. Close locking handle.
Place jug under outlet.
Push selection lever to the "COLD" position.
Machine starts rinsing.
After approx. 60 seconds push selection lever
to the "STOP" position. Empty jug and refill
water tank with fresh, drinking water.
Make sure that the selection lever is in "STOP"
position. Then plug the power plug into a
mains power socket.
After approx. 60 seconds push selection lever
to the "STOP" position. Machine stops rinsing
and power button blinks red for about 5
seconds.
1
4
7
2
5
8
Place drip grid on drip tray. Then insert drip
tray at desired position of drip tray.
Then insert drip tray at desired position of machine.
Not finding what you are looking for?