20 Most Recent Igloo Cooler Igloo 3.2 cu. ft. Refrigerator and Freezer - Page 9 Questions & Answers


If you are rearranging the things in the compartments this can cause the alarm to stay on: it depends if the door is open a long time.
My freezer has an alarm button to deactivate the alarm for this purpose.
Have you still got the user manual that came with your freezer?
If it is possible to deactivate the alarm, it will tell you how.

Freezers | Answered on Oct 08, 2018


Compressor may be bad. Also could be the relay that plugs into side of compressor that’s bad. Inexpensive, easy to replace part if it’s the relay.

Freezers | Answered on Sep 21, 2018


Dear sir/mam

kindly make it sure if there not lose connection in the light then if its ok . then check the circuit for the light.

thanks

hope answer the question

Freezers | Answered on Sep 15, 2018


ice build up or hinge failure

Freezers | Answered on Sep 10, 2018


Well I think you better get a repair technician out there like yesterday.

Freezers | Answered on Sep 06, 2018


Try first to clean the coils and compreasuer area, use a air compressor and broom,

Freezers | Answered on Sep 03, 2018


"The Igloo 100 series portable icemakers that are sold all over for about $100 have several minor issues. For ADD WATER light, there are 2 main ones. The water SENSOR is located at the top right of the unit. Remove the BACK cover with 6 screws on the bottom. Remove the TOP assy with 4 screws from inside the case. When the TOP is off, facing the unit from front, you see the small silver wire at the back right. Clean it AND the screw visible thru the hole in the plastic at the end of the sensor wire. The screw is the GROUND side of the sensor. This fixes many of the issues. But the SENSOR senses water FLOW, not water LEVEL. If the PUMP is not moving water, the sensor assumes you are OUT of water and turns on the ADD WATER light. The pump apparently burns out easily. Remove the PUMP wire connector from the CONTROL BOARD and check for continuity in the motor. Be sure your multimeter leads actually touch the connectors. The connection end is too small for most meters, so probe from the backside of the connector. If motor is good, check for 12vdc at the board side of the pump connector. Plug in, turn on. Should be 12vdc within 45 seconds. See, the water pump comes on first. When water is moving over the sensor, then the board will turn on the compressor and start freezing. "

1-leflrefchuuw4u5xiz5otxqy-3-0.jpg

Freezers | Answered on Aug 27, 2018

Not finding what you are looking for?
Igloo Cooler Igloo 3.2 cu. ft. Refrigerator and Freezer Logo

8 questions posted

Ask a Question

Usually answered in minutes!

Top Igloo Cooler Freezers Experts

Bill Boyd

Level 3 Expert

53816 Answers

Renee Knafel-Bullock
Renee Knafel-Bullock

Level 2 Expert

355 Answers

J Rosado

Level 3 Expert

1202 Answers

Are you an Igloo Cooler Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Igloo Cooler Freezers

  • Igloo Cooler Freezers

Most Popular Question

loud noise from back refrigerator

  • Freezers
Loading...