20 Most Recent
Leeson 110912.00 1 HP 208-230/460V C6T17FK6G 3-Phase General Purpose Compressor Duty Motor - Page 6 Questions & Answers
My titan 400I won't prime what can be wrong with it?
OK, Just solved this problem with my Titan 400 not priming....After searching the internet I got the clue that it was the inlet ball valve being stuck. Most said it was from leaving paint in the system or poor cleaning habits. I thought "Not me, I always do a good job cleaning the sprayer and leaving pump preserver in the system when storing". But I was wrong. After disassembling the inlet valve housing (shown in the manual) I found the valve ball stuck to the seat. After freeing the ball there was tiny bit of paint on the seat but it was enough to prevent it from functioning. Reassembled and it works fine. So maybe just luck of the draw. I don't use the system too often and it had been 6 months since the last use...still I stored it with line full of pump preservative. Symptoms were that when in prime it would not **** from the siphon tube (supply) but motor ran fine. A bit painful fix but not terrible, exercise cost me an hour, but next time would take maybe 15 minutes to correct. Hope this helps.
Not getting any air pressure
Larry when you turn your compressor on do you any sounds? I need a little more info I want to help I just need the information Good Luck Mike L
My sullair 185 will not idle down
Hi,
Please attempt to disengage the clutch of the compressor while simultaneously lowering the engine speed.
If this doesn't work, please call Suilar at 1-219-879-5451.
Thank you.
Nail gun does not fire but can smell gas
1.Clear Jams. ...
2.Inspect Your Air Supply. ...
Reload the Magazine. ...
4.Clean the Instrument. ...
5.Replace Seals and O-Rings. ...
6.Inspect for Harm. ...
7.Take It to the Help Place.
Consider
https://lumbuy.com/ for buying best quality Nail Gun Machine.
I have a ATLAS COPCO
Without more info or knowing your compressor my first question to you is,is the oil cooler clean and does the unit have good water flow. DO you have good water flow / pressure. The oil level should be about half way the sight glass running loaded. If the oil level was low ,when the thermostat opens it allows oil to flow to the cooler which lowers the oil level.Typical problems during this time of year are , , dirty oil cooler, Faulty thermostat, Faulty element temperature sensor, Low oil levels and bad oil. Also dirty oil filters restrict oil flow and can cause high element temp. problems. Try back flushing the water side of the oil cooler. Have you checked to make sure the water solenoid is opening. May have a bad coil or valve. May also have water solenoid plugged with something. What is the cooling water inlet temp and outlet temp. The W usually indicates water cooled. If not water cooled, most of the above also applies to air cooled units. just replace water with air if it fits.
Where can I get parts for a Hyundai Finish Nailer HPT-FIN16-1?
like all things
from them
or used, or new off ebay or amazon
or googling with P/n
first get the manual with part list
the find part there and search online
these steps work for mos things not too not china direct junk
top brand names not nonames (like )
po - ? - p?
Not finding what you are looking for?