20 Most Recent Honda EU6500iS Inverter Generator - Page 9 Questions & Answers


does it surge under load ? or without load, if without load it could need the injector cleaning if under load it could be the governor at fault

Honda Electrical... | Answered on Feb 19, 2015


I have a video that may help you to troubleshoot the problem.

https://www.youtube.com/watch?v=zGy9WoA537w&list=UUycoCur2JWPEhrS0qTeyIJw

Please let me know what you find I am happy to help further.

Joe

barterjoes.com

Honda Electrical... | Answered on Jan 29, 2015


PLace the throttle at full position while watching the governor arm. Loosen the clamp bolt on the governor arm and turn the governor crank in the same direction as previously noted until it stops. Now retighten the clamp bolt.

Honda Electrical... | Answered on Jan 28, 2015


If you can access throttle linkage to the carburetor, slow the engine speed to idle before turning off. As mentioned in the previous answer ... turning off the fuel valve and letting it run dry is good if you are not planning to use it real soon.

Honda Electrical... | Answered on Jan 26, 2015


Make sure the fuel valve is on, if that does not fix it you will need to drain the bowl on the bottom of the carb. What model is it

Honda Electrical... | Answered on Jan 26, 2015


There should be a switch on the unit the turns on the outlets.

Honda Electrical... | Answered on Jan 05, 2015


It may be just as simple as flashing the fields. Remove the end cap of the generator. Look for the brush holder on the top center of the housing The brushes may be worn out or the fields may have lost the residual magnetism. The brush holder has two wires going to it, a red (positive) and a ?white (negative). Hook a couple of wires to a 12 volts battery. Plug a lamp into the generator that will light up when it begins to charge. BE VERY CAREFUL!!!!! Start the generator and momentarily connect the two wires to the brush holder connections. Make sure you observe the polarity Two or three seconds is plenty. If this doesn't work remove the brush holder and check brushes.

Honda Electrical... | Answered on Dec 21, 2014


Honda GX400 either a motor car (which will have a '12V Generator' on board..) or a largish sized Honda utility engine for water pumps, fans and electricity generation of of over 5KW (5KVA)

Honda Electrical... | Answered on Dec 19, 2014


some units may have a temp sensor located on the cylinder head that may shut the engine down before it reaches the required temperature.give me the model if possible.

Honda Electrical... | Answered on Dec 18, 2014


model number would help to determine what type of switch.i would be glad to help

Honda Electrical... | Answered on Dec 18, 2014


Any engine that burns oil should be given a compression check and then have the compression rings replaced if they leak.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_e0539de310ea5ad7

Honda Electrical... | Answered on Nov 25, 2014


Remove it and soak it in "Sea Foam" carbureator cleaner. Should just be 2 screws holding it on. Get the service manual from Honda. Honda com Official Site of American Honda Motor Co Inc

Honda Electrical... | Answered on Nov 07, 2014


Either through your local Honda power equipment dealer, or online at a Honda power equipment distributor like boats.net or dealercostparts.com. I have had great service from all of these options.

Honda Electrical... | Answered on Oct 22, 2014


Most likely, the carbureator needs ot be rebuilt.

Honda Electrical... | Answered on Sep 03, 2014


either you have a crankcase with low oil or overfilled and contaminated with fuel.fill oil to first thread of filler and try again,if overfilled by fuel then you need to clean the carburetor float it may be obstructed.if oil okay and continues to shut off you may have a faulty low level sensor.

Honda Electrical... | Answered on Sep 03, 2014


has to do with emmisions e-10 is known as unleaded fuel with 10 percent ethonal

Honda Electrical... | Answered on Sep 03, 2014

Not finding what you are looking for?
Honda EU6500iS Inverter Generator Logo

13 questions posted

Ask a Question

Usually answered in minutes!

Top Honda Electrical Supplies Experts

Sheldon Dedek

Level 3 Expert

912 Answers

Mike

Level 3 Expert

4372 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Honda Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Honda Electrical Supplies

  • Honda Electrical Supplies

Most Popular Question

stops generating just idles

  • Electrical Supplies
Loading...