20 Most Recent Rowenta Steam 'n Press DA75 Iron - Page 2 Questions & Answers

To try and seal the water leak will possibly render the appliance dangerous. I would speak to Rowenta and ask the question. They may well extend the warranty if you suggest it wasn't used for say a few weeks after purchase etc.

We’re u able to fix this ? I am facing similar issues after my wife forgot to shut it off and the auto shut off might have triggered but now it doesn’t Heat up even though I the light comes on

RCD or MCB that is tripping? If MCB the iron is overloading the circuit, usually a short circuit and is often related to the power cord. If RCD power is escaping from the circuit to ground and is usually caused by an internal water leak.

They are built to shut off after about 30 sec or so if the iron is not moving and the iron is in pressing position (sole plate down). They shut off if they are not moving and standing with the sole plate vertical, in about 5 minutes. If you move the iron (like ironing) they reheat. If it doing something else the electronic control is defective. It is cheaper to replace than repair.

Similar models manual: https://www.rowentausa.com/instructions-for-use/Products/Linen-care/Steam-generator/Compact-Steam/csp/1830006489 https://www.rowentausa.com/instructions-for-use/LINEN-CARE/STEAM-STATION/COMPACT-STEAM-STATION-DG7530/csp/1830005479 https://www.rowentausa.com/instructions-for-use/LINEN-CARE/STEAM-STATION/PERFECT-STEAM-STATION-DG8520/csp/1830005299

I'm on my fifth Rowenta iron. The first four eventually started to leak. I keep buying Rowenta because I get the best results except for the leaking. I've been using filtered water even though the manual sas to use tap water. I will start o use tap water. The fifth one I bought was highly rated by Consumer Reports. If this new one starts to leak, I'll bring it back and buy a different brand.

https://www.rowentausa.com/consumer-services/contact-us https://www.rowentausa.com/consumer-services/warranty-and-repairs/repairers There does not appear to be an official repair center in Nebraska. Contact the manufacturer using the links above to request assistance, please.

need a meter and check the unit for short

on of switch not working

There is no repair parts so replace it

Pour in some vinegar (half) and some water (half) in the machine. Turn it on and let it run a bit. Make sure to do it outside since it smells badly. After that, rinse a few times before use.

You can probably buy them in a set. I’m sure one will fit.

White vinegar

It was on the box it came in.

there is a reason for the wire shorting at that point could be a dead short that caused the wire to burn or other serious problem best advice is to take it to an appliance repair shop for a diagnosis and quote or to be safe simply junk it and get a new one

Be sure the voltage and current you are using in India is correct for the unit. Is the power on the unit switchable?

It is evidently defective. If this was the first use, box it up and send it back for a refund or replacement. Most companies require to issue a return authorization form before shipping it back.

Jim , please check this video you can able tofill water. Rowenta Steamforce Iron

probably can't fix if you take it to an appliance repair ship for a quote , it will probably cost more than a new one Spring water is very high in mineral content and that would cause the leak best use DE-mineralized water as that is just pure water and is what is recommended for irons