20 Most Recent American Standard 2083.102 Standard Collection Bathtub, Right hand outlet - Page 7 Questions & Answers

0helpful
1answer

Whirpool bath starts when I press button but stops as soon as I release button

Hi Joey, The problem is likely that the switch is installed incorrectly. I'm sorry I don't recommend or advise any repair of a appliance that is water/electrical by anyone other than an authorized repair person. Furthermore, I would not use the appliance again until you have have professional repairs done.
5/20/2014 9:02:38 PM • American... • Answered on May 20, 2014
0helpful
1answer

Tub will not turn off

If your pump will not shut off when you push the button on the tub then you have a bad air switch in the motor. Rod US Parts Center
5/1/2014 2:20:44 PM • American... • Answered on May 01, 2014
0answers

Hydromassage 1063

Be the first to answer 4/14/2014 3:35:47 AM • American... • Posted on Apr 14, 2014Be the first to answer
0helpful
1answer

Hydromassage 1063

Not normal for that to happen but the jet faces on the two back jets may be turned off or down. Try turning the face of the jet clockwise and see if you get more water flow out of each jet. Rod US Parts Center
4/13/2014 11:19:33 PM • American... • Answered on Apr 13, 2014
0helpful
1answer

Pump runs normally with no water but surges when filled with water

When there is a load on the motor and it is surging this is an indication of not enough water getting to the front of the pump. Check the water flowing inside the tub going from the jet opposite the suction cover. Sounds to me like you may be getting cavitation because the pump is pulling in too many air bubbles from the jet. Close the air control and/or move the direction of the eyeball from pointing at the suction cover and see if that helps. Rod US Parts Center
4/9/2014 8:44:46 PM • American... • Answered on Apr 09, 2014
0helpful
1answer

Toilet tank is refilling slowly.

Hi AaronYC,

I'm Harvey the Master Plumbe.

Your problem is: Installed a new American Standard Cadet 3 toilet bowl and tank at home. When you turn the water supply on, the tank refills normally and stops normally. After you flush, the refill is very slow. When it refills normally the water comes out from the bottom of the pipe (i.e. the pipe that houses the float cup) and when it is refilling slowly, it comes from the top of the pipe. Sometimes (but not always), you can shut the water supply off and when you turn it back on, the flow of water goes from slow to fast instantly - but you haven't been able to recreate this consistently.

These are the facts. American Standard has been keeping costs down by out sourceing. Their toilets are now built in third world countries and parts are made cheap. They're all doing it. Quality control is pretty good but your toilet came with a bad "ballcock". That's the refill part on the left. Because it's new, if you take the ball **** back to place of purchase they should give you new. If not, they cost less than $ 10.00 and easy to replace.

Feel free contact me again!
Please give me a rating here at fixya.com before you sign off
Thank you,
Harvey your Master Plumber
4/7/2014 9:58:19 PM • American... • Answered on Apr 07, 2014
0helpful
1answer

No water flow from new american standard marquette showerhead

I think fitting of your shower is not proper. You have to fit it properly if you can or you can call a nearest Plumber to solve your problem.
3/13/2014 10:55:05 AM • American... • Answered on Mar 13, 2014
0helpful
1answer

Down stair toilet bubbles when upstair toilet is flushed. never had this problem with old toilet

The roof vent for the toilets is shared. It is the pipe (on the roof) that lets water in the drain system. When clogged, it causes what you have. A garden hose placed in the roof vent (and turned on) may clear the blockage (could be leafs or pine straw or a dead bird). Needs to be cleared... I have used a plumbers snake with 100% success....but you may not have one...so the garden hose suggestion. Be careful on the roof.
3/11/2014 3:50:29 AM • American... • Answered on Mar 11, 2014
0helpful
1answer

Remove the logo from under-mount ceramic sink

I would say if you use heat use a heat gun. Better heat but be careful, they are much hotter than you think and you do not want to damage the finish.
3/4/2014 9:32:53 PM • American... • Answered on Mar 04, 2014
0answers
0helpful
1answer

I have a jetted tub and it won't turn off. I have a single button in the back right corner and i don't know what to do!

Right now you are having to turn it on/off by using the circuit breaker or just unplugging the pump right? Is this a button you depress or an electric button like you would find on a microwave? If it is a button you depress to turn it on/off then the problem is most likely the air switch located in the motor under the skirt of the tub. If it is an electric button then it may be the control box under the tub that needs to be replaced. Rod US Parts Center 888-521-6183
2/26/2014 11:24:57 PM • American... • Answered on Feb 26, 2014
0answers

Toilet gurgles

Be the first to answer 2/4/2014 3:15:17 AM • American... • Posted on Feb 04, 2014Be the first to answer
0helpful
1answer

We have 3 toilets in the house. the tanks won't refill after flushing

You may have dirt getting into your water from the well and clogging the fill valves in your toilets. Valve assembly can be opened and cleaned out from the top. Instructions are available on AS website for your model. (Note) If you are picking up material from your well, a sediment filter should be added to your water line.
2/1/2014 1:30:37 PM • American... • Answered on Feb 01, 2014
0helpful
1answer

Why does my toilet suddenly fill the tank?

Usually seeping is from under the flapper. Replace flapper with one designed for that model. Avoid generic flappers.
2/1/2014 1:26:10 PM • American... • Answered on Feb 01, 2014
0helpful
1answer

Water wont stop running

Water is either running (1) into the overflow tube or (2) out to the toilet under the flapper at the bottom of the tank. If (1) lower the ball or float. Done differently depending on model. If (2) replace the flapper with new flapper designed for your model. (Note: Raise manually the float valve and if water still runs out the little tube that goes into the overflow tube then fill valve is defective. Replace it.)
2/1/2014 1:12:36 PM • American... • Answered on Feb 01, 2014
0answers

Roca toilet

Be the first to answer 1/15/2014 3:36:23 AM • American... • Posted on Jan 15, 2014Be the first to answer
0answers
0helpful
1answer

My American Standard R120 shower valve has excellent pressure on the cold side, no pressure on the hot side.

Could be a chunk of scale in the valve. Need to turn off water supply and take valve apart. If nothing is found, turn water supply on to give line a 'quick' flush and turn back off. If this does not help, you probably have an obstruction somewhere in the hot supply line and a plumber may be needed unless you are handy. Good luck.
1/1/2014 7:05:49 PM • American... • Answered on Jan 01, 2014
Not finding what you are looking for?
American Standard 2083.102 Standard Collection Bathtub, Right hand outlet Logo

13 questions posted

Ask a Question

Usually answered in minutes!

Top American Standard Home Experts

Mike

Level 3 Expert

4377 Answers

john h

Level 3 Expert

25188 Answers

Ekse

Level 3 Expert

13435 Answers

Are you an American Standard Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

American Standard Home

  • American Standard Home

Most Popular Question

new american standard shower

  • Home
Loading...