20 Most Recent American Standard Cambridge 5 Ft. x 32" Right-hand Drain Whirpool Tub, Whit - Page 4 Questions & Answers


Don't have a solution...but experiencing same problem on the HOT water side. Water lines were 4" too short, so I had to go back to Lowes to buy 2 more flex hoses and brass fittings (additional $25), and I have no hot water pressure, justa trickle.

American... | Answered on Jun 10, 2014


buy another one and use it as a model to put yours back together then take it back for a refund.

American... | Answered on Jun 07, 2014


I guess so as long as it does not leak. The position for your desired temperature may change.

American... | Answered on Feb 25, 2014


I assume it is a bathroom faucet. I am providing a link to an installation guide. On the last page of the guide, the exploded diagram shows where the valve is located.
Here is the link:
http://www.americanstandard.ca/assets/documents/amstdca/install/Install_1816.pdf

American... | Answered on Feb 25, 2014


Probably it is due to a losen hand shower holder. You need to take it out and fasten it.

American... | Answered on Feb 22, 2014


What are you looking for? fiber mesh concrete repairs for floors on the drain system that you have to replace a drain in? or are you speaking of 80 pound bag of ready mix to repair hole? Do you need structural strength for the repair? need more info to help out.

American... | Answered on Feb 06, 2014


It's likely that the problem is not with the drain itself, but rather with your general plumbing. It's possible that the drain isn't vented. There is supposed to be a vent pipe (to let unobstructed outside air into the system to follow along behind the water that's now drained) within 3 feet of your drain. This is so that you don't have to pull air through the drain trap (which is designed to block air passage). Sometimes these get blocked (birds and whatnot) and sometimes they just aren't there. If you have a new drain and it's properly installed, this is your most likely reason.

American... | Answered on Jan 06, 2014


I think you might need a handle remover tool. It looks like two "L"'s facing each other with a long screw going through the top of the two L's . With a T handle at the top. The two L's go up under the bottom of the faucet handle, and the long screw fits into the screw hole for the faucet handle. A dozen turns or so and the handle pops off the valve stem. Cost about 10-15 dollars at any hardware store. hope this helps.

American... | Answered on Jan 06, 2014


Be more specific?

American... | Answered on Dec 29, 2013

Not finding what you are looking for?
American Standard Cambridge 5 Ft. x 32" Right-hand Drain Whirpool Tub, Whit Logo

11 questions posted

Ask a Question

Usually answered in minutes!

Top American Standard Plumbing Experts

Bill Johnson

Level 2 Expert

306 Answers

john h

Level 3 Expert

23515 Answers

Fahr Quad

Level 3 Expert

774 Answers

Are you an American Standard Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

American Standard Plumbing

  • American Standard Plumbing

Most Popular Question

bath tubs installation

  • Plumbing
Loading...