X Treme X 500 Scooter "idle" Questions

how do i stop the engine running at a fast idle just put new injection pump on and it runs with fast idle how do i correct this Assuming it is a completely mechanical system with no electrical or ...

50cc Two Stroke Scooter Engine - Poor Idle Need to have idle turned up almost all the way to keep scooter engine running when standing still. Engine stalls out after turning choke switch to run ...

I have a 63 caddilac with a 390 and a 4GC how do i ajust the idle all i see is a fast idle ajustment and the idle air and fuel mixture screws you will have to ajust the fast Idel down an then for the ...

why wont my revo go into reverse try setting your idle down a little more. if your idle is too high, it wont shift into reverse. also check your linkage. make sure it pulls all the way out and pushes ...

...fully seated. There is a small screw which is located right next to the air intake. This is the idle stop and should be set so that the engine idles smoothly. The third screw is located on the ...

my trx 3.3 idles fine but when you turn the remote on it takes off you either need to adjust your servo or your idle screw on your controller. when you turn your remote on, it's opening up the ...

will not slow idle truck want to learch forward. i increased clutch slippage but still cannot slow the idle speed. tried new carb, hobby shop recommended replace piston and sleeve did that still no ...

How do you adjust the idle on a 1997 F150? The truck starts and idles at approximately 1000 rpm.................. after a moment or two, the idles reduces to 500-600 rpm and the truck wants to stall. ...

my 92 K1500 5.7L TBI has a high idle and when at operating temp it wants to die in drive my truck starts with high idle then when wormed up it while driving it wants to die. starts fine but when it ...

302 Ford engine purchased used-fires up ok, idles like it has cam, runs/drives normal, but when shifted from park or neutral to drive or reverse it stalls. All vacumn systems have checked out ok, ...