clutch lever, you should be able to feel a little free play before the lever actually starts pulling the cable. You should have approximatley an 1/8 inch gap between the lever and the perch when lever
Question about Yamaha Xv 250 Virago S Motorcycles
...clutch lever is in (no power to rear) or out (power to rear). After almost 30 years this switch may have failed, making the bike think that the clutch is engaged regardless of lever position. If you ...
Question about Yamaha Xv 250 Virago S Motorcycles
...clutch in and keep pushing the lever down until it dont push down any further it will only go down 1 gear at a time so you will need to push it down 4 times but you dont need to count you can just ...
Question about Yamaha Xv 250 Virago S Motorcycles
...clutch lever but that did not work also chain seems to be making excessive noise while riding From what you are describing it sounds to me like your drive chain needs adjusting & lubricating ...
...stalls unless i roll away any suggestions appriciated i realy dont want to pull it apart help please you could try riding the bike in third or fourth gear with the clutch lever pulled in and ...
Question about Yamaha Xv 250 Virago S Motorcycles
clutch lever on a 1988 yamaha virago xv250?Thanks that switch is part of the safety system & works together with the side stand switch should you attempt to engage a gear with the side stand down.
in and the sidestand must be up (there is a clutch lever switch and a sidestand switch ) The engine stop switch "kill switch" on right handlebar has to be in the RUN position to allow starter cranking
Question about Yamaha Xv 250 Virago S Motorcycles
switch wires together, but best to get a new switch(its a safety switch for a reason). there can also be a clutch switch under the lever, if it has one make sure it is also opperating and not stuck in
20 questions posted
Usually answered in minutes!
70 Questions
38 Questions
26 Questions
28 Questions
13 Questions