2000 Yamaha DT 125 R "stator flywheel" Questions

...New cdi box. but same problem sounds like the stator coil in behind the flywheel there are some electric tests for the stator but not allways correct I would try a stator You need new generator ...

...stator (behind the flywheel) and the cranckcase. The timing can't ever be that far out as there is a limited amount of movement of the stator, it is fitted with three screws in slotted holes. To ...

...flywheel off the crankshaft, then remove the 3 screws holding the stator to the cases. Unplug the electrical connection for the stator and reverse the procedure for reassembly. Use a new gasket, and ...

...you remove a stator on a 1992 honda cr250 2 stroke Stator unbolts, do you mean flywheel? You need a puller for it, it threads into the flywheel, after you remove the center bolt, left handed

...I believe the stator shattered under the flywheel. i don't have a flywheel puller. support engine weight below flywheel, with a center punch tap crank, after soaking with a penetrating

flywheel.top dead center to check the valve clearance. The timing mark can be found in the stator housing on the riders left hand side. It is behind the small round plastic plug approximately 20 mm on

...regulator, load tested your battery, and tested your stator for grounding, you may be dealing with a weak magnet in your flywheel. If everything is checking out OK then try replacing your

...type piece that has magnets afixed inside of it, as the flywheel rotates around the stator, it creates the electricity, just like a hydroelectric generator you have seen on TV only on a smaller

flywheel ( tool might be needed) 4) undo screws for stator. re-asemble in reverse order. air impact tool is good aid for removing motocycle flywheels. some rear wheel spindles may aid the removal of a

...stator and flywheel is rubbing the stator Correct, the bike will not charge. Aside from that, if the flywheel is actually bent, and it sounds that it is, you will need a new crankshaft and probably a ...