Question about Triumph Rocket III Motorcycles
...rear brake pedal operates the rear caliper and the front disc. When you tried to bleed the left front caliper you let air into the rear brake system. Bleed the rear brake and front left caliper using ...
Question about Triumph Rocket III Motorcycles
...rear brake master cylinder. Something is wrong with this as your rear brake is not working. The brake light for the rear brake is activated by a pressure switch whereas your front brake light is ...
Question about Triumph Rocket III Motorcycles
...rear brake pedal to control the rear brake and the front is controlled by a brake lever which supplies 3/4 of all stopping power. Dont ever slam down on the rear brake pedal just apply it gradually. ...
rear brake light not working The brake light is turned on and off by either of two switches on your bike. The front brake lever has a switch located in the right handlebar switch housing. When you ...
Question about Triumph Rocket III Motorcycles
...rear brake caliper about a half turn. Press the rear brake slowly until it stops and hold it there. Tighten the rear brake bleeder valve while holding the rear brake pedal down. Then, release the ...
...rear brake switch on a 1972 harley ironhead sporster? Been a long time since I've worked on one of those but the '72 model Sporty has mechanical brakes on the rear. There is a rod that runs from the ...
Question about Triumph Rocket III Motorcycles
REAR BRAKE DISC HAS 8 VIBRATION BUSHINGS THAT ARE LOUSE. Hello Dale, this is an easy job on your bike. Use a flat head screw driver and remove the brake pad cover...it will pop off. Remove the hairpin
rear brake light does not work tail light does need to know were brake light switch is? Your bike is equipped with two brake light switch, either of which should cause the brake light to come on when ...
rear brake light will not work when brake pedal is applied, both front and rear brakes run through same sensor front brake applies rear light, but rear brake pedal doesnt. where is the problem? It ...
rear brake light pressure switch. Follow the metal tube that comes out of the rear brake master cylinder going back to the rear brake. You will find a pressure switch in the line. Disconnect the wires
28 questions posted
Usually answered in minutes!
24 Questions
22 Questions
15 Questions
3 Questions
3 Questions
