Question about Suzuki GSX-R 600 Motorcycles
...low, mid range and high range rpms. 10k would fall in the Mid range power. I would let the bike warm up a little bit and tweak the middle knob on the left side of the bike and keep in mind you need ...
...power(torgue) in low RPM and less power with high RPM. I heard, that it is possible to do by adjusting exhaust valve. I do have Suzuki owner's service manual. It tells how to remove and install the ...
Question about Suzuki GSX-R 600 Motorcycles
...Backfires on decelleration.weak low rpm power. SOUNDS LIKE IT'S RUNNING LEAN. TRY PULLING THE FLOAT BOWLS OFF THE CARBS AND CLEANING THE JETS. ESPECIALLY IF IT SAT FOR A LONG TIME. FUEL TURNS TO
...low end power. Engine runs fine at high rpm but bogs at low rpm and will not pull up hill without reving engine and clutching. Engine responds normal with no hesitation on level ground and does not ...
...power, get a jet kit which comes specific for your bike and includes a bunch of different sized jets. But my honest opinion even after reaching 20,000 miles on this bike, if it isn't broken don't ...
low rpm but when you get on it it does not seem to have the power it should have and it starts to bog like a sputter. most likly needs new rings-or bad plug if you are lucky Could be your power valve.
...stahlls out. Pull started? on a YZ 125? The power valve will not allow high RPM power if it is gummed up. Low compression is due to bad rings, a different problem. You may have both
...power in the mid rpm range it rides fine at low rpms and good and high but there is just no mid range power it feels like it just doesn't want to run. Try the air filter first (make sure it's clean). ...
...low end power i just bought a yamaha blaster atv 2-stoke with many aftermarket parts and it has little take off power but once it gets mid and high rpm range it runs great. what can i do to get it ...
...power valve or high revs on my 2003 dt125r it starts to splutter but its fine at low revs. Sounds like either the bike is starving for gas at higher RPM's, or you're hitting the rev limiter. ...
142 questions posted
Usually answered in minutes!
165 Questions
69 Questions
61 Questions
52 Questions
52 Questions