2000 Suzuki VL 1500 Intruder LC "carb spec float" Questions

Ad

spec and cleand everything very thurowly and fule still flows right out of the back of all 4 carbs. Any suggestions? Float valve seats have o ring seals on some carbs, check those. Float level must be

Ad

Question about Suzuki VL 1500 Intruder LC Motorcycles

1 Answer

i need the specs for setting the floats and jets on a 1986 kawasaki gpz 1000 The float setting is 17mm frombase of carb to farthest edge of float ,holding carb  vertical

Ad

Question about Suzuki VL 1500 Intruder LC Motorcycles

2 Answers

...float chamber gasket is still on the carb, reduce the measurement by approximately 1mm. As a side note, I went to an auto parts store to buy a gauge to set mine - they didn't sell them ...

Question about Suzuki VL 1500 Intruder LC Motorcycles

1 Answer

carb kit i need the spec for float adjustement the gas comes out the over flow if the exact height is not known , a good rule of thumb , is to tilt the carb on its side (with float bowl off) and watch

Question about Suzuki VL 1500 Intruder LC Motorcycles

1 Answer

carb is positioned upside down) to the gasket surface of the float bowl as illustrated in the next picture. You can use an open-end wrench (sized per your spec), a small metric ruler, or a float level

Question about Suzuki VL 1500 Intruder LC Motorcycles

1 Answer

...need carb rebuilding new needle seats and check the floats for leaks ( put them in water see if they sink. do a thorough carb cleaning job on them and you need to check specs for float level

Question about Suzuki VL 1500 Intruder LC Motorcycles

1 Answer

...CBX. I installed new float needles and seats. Also, I adjusted float levels to factory specs. All carbs are still flooding. I PRESUME YOU THOROUGLY CLEANED THE FLOAT NEEDLE SEAT?AND INSPECTED THE ...

Question about Suzuki VL 1500 Intruder LC Motorcycles

1 Answer

...carb body at a 45-degree angle to avoid compressing the spring in the fuel inlet needle. If you find that your measurement does not match your float level spec then you can carefully bend the float ...

Question about Suzuki VL 1500 Intruder LC Motorcycles

1 Answer

carb float and what are the specs you can adjust a float by taking the little pan off of it and just bending the stop that goes to the needle valve , usually you do not have to do this to carbs , what

Question about Suzuki VL 1500 Intruder LC Motorcycles

1 Answer

...carb, the float level has to be set with the carb on an angle. To illustrate this, I'd have to send you a picture. I'd be glad to do so if you're contact me directly as this forum only allows a file ...

Not finding what you are looking for?
2000 Suzuki VL 1500 Intruder LC Logo

229 questions posted

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6437 Answers

ROB

Level 3 Expert

858 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...