...messing up the one you are taking out but don't mess up the shaft. to do it right you have to remove the case on the clutch side and pull the shaft out from that side and them replace the
shaft seal, drive-shaft ( sprocket shaft ) seal, Kick shaft seal. shift drum switch seal, crank shaft seals and clutch shaft seal. Also, there is the right outer case cover gasket, oil filler "O" ring
Question about KTM Motorcycles
...shaft seal and a primary cover gasket and oil.First drain your oil.Remove your kick starter .Remove your primary cover.Remove entire clutch assembly.You will need air gun or a clutch holding tool to ...
...seal at the shift shaft that probably needs to be replaced. Sometimes that seal can be removed without pulling the shift shaft. Remove the shifter and degrease the area around the shaft.Carefully ...
...shaft seal Hey, I have a 2008 Qlink XP 200 and I have an oil leak I know where it's coming from just don't know what part to get. The leak is coming from left side in front of chain guard at the ...
shaft and seal, carefully pry the old seal out with a small flat blade screwdriver. Apply some grease to the inside diameter of the new seal, slide it over the shift shaft (clean it first) - and press
case then slide a new seal onto the shift shaft and seat it in the cavity. The only other way is to remove the shift shaft and then pry out the old seal. Sort of the same thing but a bit more mannerly
Oil leaks from where the shift lever goes into the trans. Cover. The bike fell on its side during transport. most likely the shift shaft is bent replace the shaft and shaft seal
Bent shifter &shaft now leaks oil. Do I have to split the case to replace seal? no but the problem is not the seal you need to replace the shift shaft and the seal.
18 questions posted
Usually answered in minutes!
8 Questions
3 Questions
2 Questions
2 Questions
0 Questions