... The reed valve assembly should hold solvent withot leaking. Remove for test. Disassemble and clean reeds and reed seat. Perfect seal is very important. Good luck, Techjoel the best way to tell is ...
...80 HAS 65 PSI COMPRESSION AFTER TOP END REBUILD VERY HARD STARTING You may have a problem with your reeds.If you have done a rebuild because something internally has destroyed itself then the chances ...
...take off 1st 2nd gear it runs like the plug is filed the guy that sold it to me said he trimmed the reeds to get a better bottom end take off but to me it seems like it gets to much fuel or air ...
my kx 2005 was runnin great them started bogging randomly changed reeds top end and cleaned carb... Well - not knowing the condition of the bike it could be a lot of things. I would start with a fresh
kx 125 1992 wont start was going great just stopped,can kickstart all day will not go just makes a puff noise,please help wont 2 ride again ,cheers tankman1 sounds like the rings are fried and needs a
...air and reassemble. You should also pull off your reed cage and check to make sure that your reeds aren't cracked or broke. If your bike was runninng before and you give your carb a good ...
Question about kawasaki KX 125 Motorcycles
...it...good luck to you friend...Tim I had the same problem with my bike the problem is it needs new reeds. If it wont start from kicker and wont idel sounds like it low on compression it could be the ...
can i put a bigger reed valve in my kx 125 No u can't.
Question about kawasaki KX 125 Motorcycles
My 03 KX125 just had a new crank kit and top end installed. Bike ran great first few times out. Now it's misfiring under a load. It revs great in neutral and is very responsive, but when accelerating ...
326 questions posted
Usually answered in minutes!
29 Questions
21 Questions
7 Questions
6 Questions