2003 KX125 Clutch Problem I have problems with my 2003 KX 125 clutch. When releasing the clutch lever, the bike jumps forward............. in other words, the clutch doens't release slowly and ...
1987 kx125 clutch wont engage bouthg this bike used eith this problem no matter what you do the clutch wont release. with lever fully pulled its still in gear i have replaced the cluthes and steels. ...
Question about kawasaki KX 125 Motorcycles
...something inside not working Remove the right side cover and check the operation of the side case clutch lever by looking at it from the inside. If it is operating freely and the cam on the arm
Question about kawasaki KX 125 Motorcycles
i need to know how to remove lutch from kawasaki 65 1- Remove nuts, clutch spring plate and springs 2 Feed a rolled-up rag between both primary reduction gears to prevent the clutch from turning, then
Question about kawasaki KX 125 Motorcycles
my clutch doesn't engage all the way. i can't kick it in gear while holding the clutch. i can't sit with it in gear while holding the clutch. try adjust the clutch at the lever if that doesnt work the
clutch slipping when i pull out clutch engages but bike dont move very fast and the engine revse high do i need new clutch this is a 89 kx 125 Clutch plates are probably toasted. Drain the oil, remove
Question about kawasaki KX 125 Motorcycles
the clutch will not spring back after you pull the clutch handle Unhook both ends of your clutch cable if it is binding at all replace it. If the lever on the motor does not go all the way back to ...
Question about kawasaki KX 125 Motorcycles
How do I install the clutch release shaft on a KX 125? I have a 2003 KX 125 and I was replacing the clutch cable when the clutch release shaft came out slightly and would not go back in place. I am ...
clutch in .transmission in 1st gear ,wheel still turns . adjusted clutch still won't let you set in gear with clutch in ? any suggestions ? This could be 2 things : Wrong oil or your clutch is old and
i have 2003 kawasaki kx 125 when you put it in gear with clutch in it jumps forward and dies. where do i start with this? make sure clutch ,is disengaging properly when you pull in clutch lever,adjust
326 questions posted
Usually answered in minutes!
29 Questions
21 Questions
7 Questions
6 Questions