2000 Harley Davidson FLHTCUI Electra Glide Ultra Classic "socket removes head bolts" Questions

alan bolt size on transmition tank for a 2001 road king Usually these bolts are 1/4" X 20 threads per inch socket head bolts that use a 3/16 hex key to remove. Steve

...socket head bolt in a recess under there. It takes a 6mm allen wrench or hex key to remove the bolt. It is designed to take a special "piloted" key but you can get it out with a NEW hex key. I prefer ...

...is in the way of removing the starter. Take the large cable off of the starter and the two large socket head bolts that hold the starter motor in. Nothing real tricky about this job. Good Luck ...

...head screw to detach flange at rear of console from clip nut on fuel tank weldment. 8. Lay a clean shop towel on forward part of rear fender. 9. Remove filler cap from neck of fuel tank. Remove ...

...head bolts toward the rear of the opening and box. I believe its a T40 bit for that. Once thats done, remove the covering and set it aside.4. Youll see the battery. It takes a 10mm socket to undo. ...

...socket head bolts), two bolts or nuts on the inside at the transmission end, and the one bolt down low on the backside of the inner primary. The inner primary should come off easily once you get all ...

...head screw driver tap back the bolt lock tab then use an (i believe 8mm socket to remove this screw) its a long one at that about 4-5 inches long. then pull out the pinion gear now go to the other ...

take a old 17mm socket and grind it down a little to get it on the bolt head. I think one bolt is for the oil in the engine and the back one is for the dry sump, there is oil in both at any given time

...Plug is 18-21.5 ft-lbs Cylinder head nuts that require a 14mm socket are torqued to 21-24 ft-lbs. Those that require a 13mm socket are torqued 16.5-19.5 ft-lbs. goodluck How do I remove the

...socket but I may be off by a millimeter or 2. Remove bolt(s) on one side then turn steering head to other side and remove bolts there. Pull down lock out of steering head and disconnect connector. ...