Honda Pressure Washer PSI 3000 "shut down trigger released" Questions

locknut and adjust the allen screw slightly outwards toward the switch. Pull the trigger a few times and verify the motor starts up and shuts down when you release it. Tighten locknut. Hope that helps

...shut down the unit! Add some power steering fluid to your supply hose (about 3 or 4 ounces at a time) and restart the unit with the trigger pulled. Allow the oil to flow through the pump for 1 - 2 ...

...Shut off the water and connect the gun. Turn the hose back on, and operate the gun for several minutes, pulling the trigger and releasing. This alternately allows the water pressure to build up on ...

...the unit with the wan trigger engaged water coming out to spray. If the unit runs while wan trigger is engaged and shut down when released your unloader valve isn't working. Hope this helps God ...

...shut down the pressure as it should. It stays stuck on. The other info is how long you've had the washer, but my hunch is that maybe you have hard water, and the deposit build up may be getting the ...

engine shuts down when nozzle trigger is released Check the pressure bypass valve.

when i release trigger the motor wont stop. The switch in unit that is supposed to detect pressure buildup and shut down is not working.

...down? Karcher 3.86 electric pressure washer: With everything hooked up, water turned on, it makes a very loud humming noise until I pull the trigger on the wand and then it works normally. But when I ...

...down the trigger, hold the unit, and pull the starter rope at the same time.....Very disappointed in hot starting capabilities of this pressure washer.... When you run the unit and shut if off, ...

...the trigger the moter bogs down and shuts off. thanks Bob Oil level in pump and motor OK? Spark plug not fouled? Has it sat for a while - carb dirty? Running (loaded) throttle rpm not high